Weider WESY37530 user manual Cable is over the welded bar inside

22. Lubricate an M10 x 81mm Bolt (85) with grease.		22
	Attach the left Butterfly Arm (20) to the Left Fly			75
	Pivot (21) with the Bolt and an M10 Nylon				20
	Locknut (75).
	Attach the right Butterfly Arm (20) to the Right				85
	Fly Pivot (22) in the same manner.
				21	Lubricate
			20	22
	Cable Assembly	23
23.				5	38
	IMPORTANT: Refer to the CABLE DIAGRAMS
				75 58
	on pages 27 and 28 for help identifying the
	cables.			74
					74
	Locate the High Cable (61). Route the small ball			Large
				Ball
	on the Cable (61) through the Right Upright (5)				58
	and under a 90mm Pulley (38). Make sure the			61	86
	Cable is over the welded bar inside the
	Upright. Attach the Pulley inside the Upright with
	an M10 x 78mm Bolt (86), two M10 Washers
	(74), two 17mm Spacer (58), and an M10 Nylon
	Locknut (75).	24		10
24. Wrap the High Cable (61) over a 90mm Pulley					38
	(38). Attach the Pulley to the Right Top Frame
	(10) with an M10 x 45mm Bolt (78) and an M10
	Nylon Locknut (75).			75
					78
				61
25. Wrap the High Cable (61) under a 90mm Pulley		25
	(38). Attach the Pulley and a Cable Trap (37) to
	the first set of holes from the top of the Double			37
	“U”-bracket (41) with an M10 x 48mm Bolt (23)				61
	and an M10 Nylon Locknut (75). Make sure the				38
	Cable Trap is turned to hold the Cable in the
	groove of the Pulley.				41
				75
					23
		13