Weider WESY37530 user manual

Page 15

31.Route the Short Cable (62) over a 90mm Pulley

(38).Attach the Pulley to the front bracket on the Right Top Frame (10) with an M10 x 45mm Bolt

(78)and an M10 Nylon Locknut (75).

32.Thread an M12 Nut (80) onto the Short Cable

(62)as far as it will go. Slide a 50mm Washer

(59)onto the Cable and thread the Cable into the Weight Tube (34) until the Cable is tight. Tighten the Nut against the Washer.

33.Locate the Low Cable (63). Route the Cable under a 90mm Pulley (38). Attach the Pulley inside the bracket on the Left Base (2) with an M10 x 45mm Bolt (78) and an M10 Nylon Locknut (75).

34.Wrap the Low Cable (63) around a 90mm Pulley (38). Attach the Pulley inside the Left Leg (8) with an M10 x 78mm Bolt (86), two M10 Washers (74), two 17mm spacers (58), and an M10 Nylon Locknut (75).

31
10	Front
	Front
	Bracket
78	75
78	38
	62
32
62
80	34
59
33
	38
	75
2
78
	63
34
	74
8	75
	75
	58
74	63
	38
58
86

Image 15

Contents QUESTIONS? Model No. WESY37530 Serial NoCustomer HOT Line Table of Contents Important Precautions Before YOU Begin Right SideLeft Side Make Assembly Easier for Yourself AssemblyTighten the Locknuts yet Frame AssemblyPage Do not tighten the Locknuts yet Guides 9. Make sure the slots for the Weight On the bottom of the WeightsPin not shown are on the indicated side Tighten the M10 Nylon Locknuts 75 used in steps Locknuts yetOpen the part bag labeled ARM Assembly Arm AssemblyCap onto the axle. Repeat with the Right Fly Pivot EasilyOuter Cap 47. Make sure the teeth on Rings are toward the Cap, as shownCable Trap is turned to hold the Cable Groove of the Pulley Cable is over the welded bar insideDo not tighten the Locknut yet Locate the Short Cable 62. Attach the eyeletPage Page Page Page Cable Trap is turned to hold the Cable Place Remove the M10 Nylon Locknut 75 used Step Remove the M10 Nylon Locknut 75 used in step Locate and open the parts bag labeled Seat AssemblyPage Store the Curl Pad out of the way of the weight system AdjustmentsAdjusting the Backrests Adjusting the Curl PADChanging the Weight Setting Weight Resistance Chart Weight High Press LEG Butter LOW Pulley ARM FLY ARM LeverLbs Tightening the Cables TroubleshootingCable Diagrams High CableShort Cable Low Cable Exercise Guidelines Muscle Chart Cooling DownStaying Motivated Thursday Aerobic Exercise Date Exercise Weight Sets RepsDate Aerobic ExerciseR1003A Part Identification CHART- Model No. WESY37530Page Page Qty Description Part LIST-Model No. WESY37530WESY37530 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT