Weider WESY37530 Guides 9. Make sure the slots for the Weight, On the bottom of the Weights

Page 9

	9. Slide two Weight Bumpers (50) onto the two	9
	Weight Guides (9).	9
	Weight Guides (9).
			9
	Attach the Weight Guides (9) to the Right Base		50
	(1) with two M10 x 67mm Bolts (88), four M10		50	50
	Washers (74), four 12mm Spacers (57), and two			50
	Washers (74), four 12mm Spacers (57), and two
	M10 Nylon Locknuts (75).
		88		88
				88
		74		74
				74
		57		57
				57
			1
		57		57
		57	74
			74
		75		75
	10. Slide sixteen Weights (30) onto the Weight	10
	Guides (9). Make sure the slots for the Weight	10
	Guides (9). Make sure the slots for the Weight	Lubricate		9
	Pin (not shown) are on the indicated side and	Lubricate		9
	on the bottom of the Weights.			31
	Press a Weight Tube Bumper (35) into a Weight
	Tube (34). Insert the Weight Tube into the stack
	of Weights (30) as shown.		Pin	Pin
			Pin
	Lubricate the indicated holes in a Top Weight (31)		Groove
	Lubricate the indicated holes in a Top Weight (31)
	with grease. Slide the Top Weight onto the Weight			34
	Guides (9). Make sure that the groove on the
	Top Weight for the Weight Tube (34) pin is on
	the bottom of the Top Weight.
			Slot	35
				30

9

Image 9

Contents QUESTIONS? Model No. WESY37530 Serial NoCustomer HOT Line Table of Contents Important Precautions Before YOU Begin Right SideLeft Side Make Assembly Easier for Yourself AssemblyTighten the Locknuts yet Frame AssemblyPage Do not tighten the Locknuts yet Guides 9. Make sure the slots for the Weight On the bottom of the WeightsPin not shown are on the indicated side Tighten the M10 Nylon Locknuts 75 used in steps Locknuts yetOpen the part bag labeled ARM Assembly Arm AssemblyOuter Cap 47. Make sure the teeth on EasilyRings are toward the Cap, as shown Cap onto the axle. Repeat with the Right Fly PivotCable Trap is turned to hold the Cable Groove of the Pulley Cable is over the welded bar insideDo not tighten the Locknut yet Locate the Short Cable 62. Attach the eyeletPage Page Page Page Cable Trap is turned to hold the Cable Place Remove the M10 Nylon Locknut 75 used Step Remove the M10 Nylon Locknut 75 used in step Locate and open the parts bag labeled Seat AssemblyPage Adjusting the Backrests AdjustmentsAdjusting the Curl PAD Store the Curl Pad out of the way of the weight systemChanging the Weight Setting Weight Resistance Chart Weight High Press LEG Butter LOW Pulley ARM FLY ARM LeverLbs Tightening the Cables TroubleshootingCable Diagrams High CableShort Cable Low Cable Exercise Guidelines Muscle Chart Cooling DownStaying Motivated Date Exercise Weight Sets RepsAerobic Exercise Thursday Aerobic Exercise DateR1003A Part Identification CHART- Model No. WESY37530Page Page Qty Description Part LIST-Model No. WESY37530WESY37530 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT