Weider WESY37530 user manual Troubleshooting, Tightening the Cables

Page 26

TROUBLESHOOTING

Make sure all parts are properly tightened each time the weight system is used. Replace any worn parts immedi- ately. The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.

TIGHTENING THE CABLES

Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is slack in the cables before resistance is felt, the cables should be tightened. To tighten the cables, first insert the weight pins into the centers of the weight stacks. Slack can be removed from the cables in several ways:

See drawing 1. Remove an M10 Nylon Locknut (75), M10 x 48mm Bolt (23), 90mm Pulley (38), and Cable Trap (37) from the Double “U”-bracket (41). Reattach the Pulley and the Cable Trap between a set of holes closer to the center of the “U”-bracket with the Bolt and Locknut. Make sure the Cable Trap is turned to hold the Cable in the groove of the Pulley.

See drawing 2. To tighten the Short Cable (62), loosen the M12 Nut (80) away from the 50mm Washer (59). Screw the Cable into the Weight Tube (34) and retighten the Nut against the Washer.

1

 

 

41

23

75

 

37

38

 

2

 

 

62

 

80

34

59

 

Do not overtighten the cables. If the cables are overtightened, the top weights will be lifted off the weight stacks.

If a cable slips off the pulleys repeatedly, it may have become twisted. Remove the cable and re-install it. If the cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.

26

Image 26
Contents Customer HOT Line QUESTIONS?Model No. WESY37530 Serial No Table of Contents Important Precautions Left Side Before YOU BeginRight Side Assembly Make Assembly Easier for YourselfFrame Assembly Tighten the Locknuts yetPage Do not tighten the Locknuts yet Pin not shown are on the indicated side Guides 9. Make sure the slots for the WeightOn the bottom of the Weights Locknuts yet Tighten the M10 Nylon Locknuts 75 used in stepsArm Assembly Open the part bag labeled ARM AssemblyRings are toward the Cap, as shown EasilyOuter Cap 47. Make sure the teeth on Cap onto the axle. Repeat with the Right Fly PivotCable is over the welded bar inside Cable Trap is turned to hold the Cable Groove of the PulleyLocate the Short Cable 62. Attach the eyelet Do not tighten the Locknut yetPage Page Page Page Cable Trap is turned to hold the Cable Place Remove the M10 Nylon Locknut 75 used Step Locate and open the parts bag labeled Seat Assembly Remove the M10 Nylon Locknut 75 used in stepPage Adjusting the Curl PAD AdjustmentsAdjusting the Backrests Store the Curl Pad out of the way of the weight systemChanging the Weight Setting Lbs Weight Resistance ChartWeight High Press LEG Butter LOW Pulley ARM FLY ARM Lever Troubleshooting Tightening the CablesShort Cable Cable DiagramsHigh Cable Low Cable Exercise Guidelines Staying Motivated Muscle ChartCooling Down Aerobic Exercise Exercise Weight Sets RepsDate Thursday Aerobic Exercise DatePart Identification CHART- Model No. WESY37530 R1003APage Page Part LIST-Model No. WESY37530 Qty DescriptionWESY37530 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty