Whirlpool W10054070A manual ElectricalRequirements-CanadaOnly, If connecting by direct wire

Page 6

If connecting by direct wire:

Power supply cable must match power supply (4-wire or 3-wire) and be:

Flexible armored cable or nonmetallic sheathed copper cable (with ground wire), protected with flexible metallic conduit. All current-carrying wires must be insulated.

10-gauge solid copper wire (do not use aluminum).

At least 5 ft (1.52 m) long.

To supply the required 4 wire, single phase, 120/240 volt, 60 Hz., AC only electrical supply on a separate 30-amp circuit, fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Connect to an individual branch circuit.

This dryer is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-30R wall receptacle. The cord is 5 ft (1.52 m) in length. Be sure wall receptacle is within reach of dryer’s final location.

GROUNDING INSTRUCTIONS

For a grounded, cord-connected dryer:

This dryer must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current.

This dryer uses a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

For a permanently connected dryer:

This dryer must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the dryer.

WARNING: Improper connection of the equipment- grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the dryer is properly grounded. Do not modify the plug on the power supply cord: if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

SAVE THESE INSTRUCTIONS

ElectricalRequirements-CanadaOnly

WARNING

Electrical Shock Hazard

Plug into a grounded 4 prong outlet.

Failure to do so can result in death or electrical shock.

It is your responsibility

To contact a qualified electrical installer.

To be sure that the electrical connection is adequate and in conformance with the Canadian Electrical Code, C22.1-latest edition and all local codes. A copy of the above codes standard may be obtained from: Canadian Standards Association, 178 Rexdale Blvd., Toronto, ON M9W 1R3

CANADA.

4-wire receptacle 14-30R

Do not use an extension cord.

If you are using a replacement power supply cord, it is recommended that you use Power Supply Cord Replacement Part Number 3394208. For further information, please reference the service numbers located in the “Assistance or Service” section of this manual.

GROUNDING INSTRUCTIONS

For a grounded, cord-connected dryer:

This dryer must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current.

This dryer is equipped with a cord having an equipment- grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

WARNING: Improper connection of the equipment- grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the dryer is properly grounded. Do not modify the plug provided with the dryer: if it will not fit the outlet, have a proper outlet installed by a qualified electrician.

SAVE THESE INSTRUCTIONS

6

Image 6
Contents Guided’utilisationetd’entretien W10054070ATable of Contents ÍndiceDryer Safety Your safety and the safety of others are very importantInstallation Instructions ToolsandPartsLocationRequirements Electrical Requirements-U.S.A.Only Mobile home Additional installation requirementsMobile home installations require It is your responsibilityIf connecting by direct wire ElectricalRequirements-CanadaOnlyStyle 1 Power supply cord strain relief Power Supply Cord Direct WireInstall strain relief ElectricalConnection-U.S.A.OnlyWire connection Power supply cord Style 2 Direct wire strain reliefWire connection Direct Wire Remove center silver-colored terminal block screwBDE CG F Optional 3-wire connection If using an existing vent system VentingRequirementsIf this is a new vent system Vent material PlanVentSystem Alternate installations for close clearancesSpecial provisions for mobile home installations Determine vent pathVent system chart Install VentSystemInstall LevelingLegs ConnectVentReverseDoorSwing Remove the door assemblyReinstall the door Reverse the strikeCanada CompleteInstallationU.S.A If the dryer will not start, check the followingStartingYourDryer Press PAUSE/CANCELDryer USE To use an Automatic CycleStopping,PausingorRestarting DryingandCycleTipsStatusLights Cycles Modifiers Options Endof CycleSignal DryingRackOptionChangingCycles,Modifiers andOptions CleaningtheLintScreen CleaningtheDryer LocationCleaningtheDryerInterior Dryer CareChangingtheDrumLight TroubleshootingVacationandMovingCare DryerOperationDryerResults Dryer displaying code messageAssistance or Service TheU.S.AInCanada Whirlpool Corporation Major Appliance Warranty CallPage Seguridad DE LA Secadora Su seguridad y la seguridad de los demás es muy importanteInstrucciones DE Instalación HerramientasypiezasRequisitos deubicación Espacios de instalación Dimensiones de la secadoraRequisitos eléctricos -Sóloen EE.UU Usted es responsable deSi el contacto de pared luce como éste Conexión eléctricaSi emplea un cable de suministro eléctrico Si hace la conexión con cableado directoConexión eléctrica-SóloenEE.UU Cable de suministro eléctrico Cable directoInstale el protector de cables Alambre de 4 hilos se recomienda Conexión de 4 hilos Cable de suministro eléctricoEstilo 2 Protector de cables para cable directo Alambre de 3 hilos si no dispone de alambre de 4 hilosConexión de 4 hilos Cable directo Conexión de 3 hilos Cable de suministro eléctrico Conexión de 3 hilos Cable directo Si usa un sistema de ventilación existente RequisitosdeventilaciónConexión opcional de 3 hilos Si éste es un nuevo sistema de ventilaciónPlanificacióndelsistemadeventilación Determinación de la vía del ducto de escape Instalación del sistemadeventilaciónInstalaciones alternas para espacios limitados Cuadro del sistema de ventilaciónInstalacióndelaspatasniveladoras Conexióndel ductodeescapeNivelacióndelasecadora Abra la puerta de la secadora Cómo invertirel cierredelapuertaCómo quitar el ensamblaje de la puerta Cómo invertir el topeCompletelainstalación-EE.UU Si la secadora no funciona, revise lo siguienteUSO DE LA Secadora PuestaenmarchadelasecadoraPara usar un ciclo automático Para reanudar la marcha de la secadora Para hacer cambios durante un ciclo automáticoCómo detener,pausaryvolveraponeren marcha Cómo funciona el sistema de secado AccelerCareSugerenciasdeciclosy secado LucesdeestadoCiclos Modificadores OpcionesSeñal defin deciclo EndofCycleSignal Cambiodeciclos,modificadores yopcionesOpción deestantedesecado Limpiezadel filtrodepelusa Cuidado DE LA SecadoraLimpiezadellugardondeestálasecadora Limpieza de cada cargaCambiodelaluz del tambor Limpiezadel interiordelasecadoraEliminacióndepelusaacumulada CuidadodurantelasvacacionesymudanzasSolución DE Problemas FuncionamientodelasecadoraResultadosdelasecadora ¿Está el filtro de pelusa obstruido con pelusa?¿Está la secadora ubicada en un armario? Ayuda O Servicio Técnico Whirlpool Corporation En EE.UU., llame al 1-800-253-1301. En Canadá, llame alSécurité DE LA Sécheuse Votre sécurité et celle des autres est très importanteInstructions D’INSTALLATION Exigences d’emplacementOutillageetpièces Spécifications électriques-PourleCanada Seulement Dimensions de la sécheuseLinstallation dans une maison mobile exige Dégagements de séparation à respecterConduit métallique rigide ExigencesconcernantlévacuationEn cas dutilisation du système dévacuation existant Conduit métallique flexibleBrides de serrage Les styles de clapets recommandés sont illustrés ci-dessousPlanification dusystèmed’évacuation ÉvacuationDéterminer litinéraire dacheminement du conduit Une réduction de la longévité de la sécheuseTableau des systèmes dévacuation Raccordementduconduitd’évacuation Installation dusystèmed’évacuationInstallation despiedsderéglagedel’aplomb Réglagedelaplomb dela sécheuseDépose de la porte Réinstallation de la porteInversiondusensdouverturedelaporte Inversion de la gâcheAcheverlinstallation Fermer la porte vérifier l’engagement de la gâcheSi la sécheuse ne démarre pas, vérifier ce qui suit Utilisation DE LA Sécheuse MiseenmarchedelasécheuseUtilisation dun programme automatique Pour mettre la sécheuse en pause ou larrêter à tout moment Arrêt,pauseouremiseenmarcheConseils pourleséchageetles programmes Pour remettre la sécheuse en marcheTémoins lumineux ProgrammesModificateurs Signaldefin deprogramme Modification des préréglages de niveau de séchage OptiondegrilledeséchageChangement des programmes après avoir appuyé sur Start Utilisation de la grille de séchageNettoyagedelemplacementdelasécheuse NettoyagedufiltreàcharpieNettoyage avant chaque charge Déménagement Nettoyagedel’intérieurdelasécheuseRetraitdelacharpieaccumulée Changementdel’ampouled’éclairage Du tambourDépannage Fonctionnementdela sécheuseLe filtre à charpie est-il obstrué de charpie? La sécheuse est-elle installée dans un placard?Résultats delasécheuse Le conduit dévacuation a-t-il la longueur appropriée?Taches sur la charge ou sur le tambour Temps de programme trop courtCharpie sur la charge Charges avec faux plisPour plus d’assistance Assistance OU ServiceSi vous avez besoin de pièces de rechange Pour trouver des pièces de rechange FSP dans votre régionGarantie DES Gros Appareils Ménagers Whirlpool Corporation Composer le 1-800-253-1301. Au Canada, composer leW10054070A