Pioneer PRS-A900 Connecting the Speaker Output Terminals, Solderless Terminal Connections

Solderless Terminal Connections

•Do not connect a cord having an exposed core wire to the power terminals of this amplifier (Power terminal, GND terminal, System remote control terminal). Disconnection or breakage of the core wire can cause a fire or short-circuit.

•Since the wire will become loose over time, it must be periodically inspected and tightened as necessary.

•Do not solder or bind the ends of the twisted wires.

•Fasten while making sure to not to clamp the insulating sheath of the wire.

•Use the supplied hexagonal wrench to tighten and loosen the terminal screw of the amplifier. Securely fasten the wire with the terminal screw. However, since excessively tightening the terminal screw of the System remote control has the risk of damaging the wire, be careful not to tighten exces- sively by observing the status of the wire when tightening.

Connecting the Speaker Output Terminals

Use a 12 AWG to 18 AWG wire for the speaker wire.

1.Expose the end of the speaker wires using nippers or a cutter by about 14 mm to 16 mm.

14 mm to 16 mm

2.Connect the speaker wires to the speaker output terminals.

•Fix the speaker wires securely with the termi- nal screws.

Terminal screw

Speaker wire

Speaker output terminal

3.Put the wire ties in the slits and wrap the wire ties around the wires.

•Make sure the wires are connected and attached properly before wrapping the wire ties around the wires.

•Wrap the wire tie around the wire insulation, not the stripped wire.

•Cut off any excess portions of the wire ties.

Wire tie

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS êìëëäàâ

8