Korg V2 manual Auto Resample through IFX, Sampling, Check the resampled data

If “Save to” is set to DISK, you can use the page menu command “Select Directory” (0–1N ☞PG p.96) to spec- ify the save-destination for the WAVE file that will be created by sampling.

■Sampling

8Press the SAMPLING [REC] key and then the SAM- PLING [START/STOP] key.

9Play the instrument etc. that is connected to the AUDIO INPUT jack you specified in “Source Audio.”

0When you are finished playing, press the SAMPLING [START/STOP] key.

■Listen to the sampled data

•If you selected “Save to: RAM,” play the C2 key to hear the sample.

•If you selected “Save to: DISK,” use the page menu command “Select Directory” (0–1N ☞PG p.96) to hear the sample.

3. Auto Resample through IFX

This automatically makes the appropriate settings for auto resampling through the insert effects (IFX).

■Setup

1Select “Auto Sampling Setup” to open the dialog box.

2Use the radio buttons to select Auto Resample through IFX.

3Use “IFX” to select the insert effect that you want to use for auto resampling.

4Press the OK button to execute “Auto Sampling Setup.” If you decide not to execute, press the Cancel button. (For the automatically-set parameters and their values, ☞p.60. For examples of using the automatically-set parameters, refer to ☞BG p.107)

■Resample

5Specify the Key assigned to the sample that you want to resample. (☞PG p.98)

6Make settings for the insert effect. To check the sound, press the key that you specified in Key.

7Press the SAMPLING [REC] key and then the SAM- PLING [START/STOP] key.

The sample will automatically play back, and resampling will begin. When the sample finishes playing, resampling will also end.

■Check the resampled data

• Play the key you specified in Key.

To prevent the insert effect from being applied “in duplicate” when you listen to the resampled data, “BUS (IFX) Select” (P8 8–1b ☞PG p.122) will automatically be set to L/R when resampling ends. If you want to apply IFX and resample once again, you will need to change this setting back to the same IFX.

Use “Bank” (0–1c ☞PG p.90) to specify the sampling- destination sample memory (RAM).

Add the contents of “0–1O: Auto Sampling Setup” to the explanation in “Parameter Guide” 0–1 Recording Page Menu Command (☞PG p.92).

Disk

Global

Other functionality Program Combination Sampling

59