Installation Instructions —
WARNING
Fire Hazard
Do not install this grill on or near combustible materials.
Doing so can result in death or fire.
IMPORTANT: If grill is to be installed in a combustible enclosure, return this unit and replace it with the model which is manufactured for use in a combustible enclosure.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.
WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Natural Gas Use
This installation must conform with local codes and ordinances**. In the absence of local codes, installations must conform with either the National Fuel Gas Code ANSI Z223.1, or
1. Place grill into outdoor enclosure, but leave enough room in back to connect to gas supply.
WARNING
Explosion Hazard
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.
Examples of a qualified person include:
licensed heating personnel, authorized gas company personnel, and,
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
2. Make gas connections.
A combination of pipe fittings must be used to connect the grill to the existing gas line.
•If local codes permit, use an outdoor flexible stainless steel tubing gas connector,
•
1/2" grill
rear of gas pipe grill
flexible gas connector
Copies of the standards listed may be obtained from:
*CSA International
8501 East Pleasant Valley Rd. Cleveland, Ohio
**for local codes, contact your local building inspector
3. Open shutoff valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe.
valve open
valve closed
4. Test all connections by brushing on an approved
5. Open the hood.
6. For models equipped with rotisserie, remove the rotisserie’s skewer from the grill.
7. For models with side burners:
Remove side burner cover from the top of the carton that is located on the grill grate. Remove bubble wrap from side burner cover and set aside.
Open carton located on the grill grate. Remove side burner grate, unwrap and set aside.
Remove burners and burner caps from carton and unwrap. Install each set of burners and caps inside the side burner cavity as shown.
notch
burner
cap
burner
| alignment | |
| tab | |
Install side |
| |
burner grate | cover | |
and cover | ||
extension | ||
(with extension |
| |
toward grill) |
| |
as shown. | burner | |
| grate | |
Properly dispose |
| |
of all packing |
| |
material. |
|
®T eflon is a registered trademark of E.I. Du Pont de Nemours and Company.
9