Weber 89478 manual To connect the hose to the cylinder

Page 10

GAS INSTRUCTIONS

To connect the hose to the cylinder:

A)Pass the regulator hose through the side panel opening to the inside of the base cabinet.

B)Locate hose retention clip (1) on regulator hose. Secure into slot (2) on underside of tank scale.

WARNING: The hose must be secured to the tank scale with the Hose Retention Clip. Failure to do so could cause damage to the hose resulting in a fire or explosion which can cause serious bodily injury or death, and damage to property.

The LP cylinder is installed inside the base cabinet, on the tank scale (right side).

C)Open base cabinet doors.

D)Turn the LP cylinder so the opening of the valve is either to the front or side of the Weber® gas barbecue. Lift and hook the cylinder onto the fuel gauge.

E)Lift tank up into position on the tank scale.

F)Loosen the cylinder lock wing nut. Swing the cylinder lock down. Tighten the wing nut.

Some LP tanks have differing top collar assembles. (The top collar is the metal protective ring around the valve.) One series of tanks mount with the valve facing front

(a). The other tanks mount with the valve facing away from the fuel scale (b). Weber recommends the use of cylinder manufacturer’s Manchester and Worthington, with a

47.6lb water capacity. Other cylinders may be acceptable for use with the appliance provided they are compatible with the appliance retention means (see illustrations).

G)Remove the plastic dust cover from the valve.

H)Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand- tighten only.

Note: This is a new type of connection. It tightens clockwise and will not allow gas to flow unless the connection is tight.The connection requires tightening by hand only.

WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.

You will need: LP cylinder, a soap and water solution and a rag or brush to apply it.

I)Mix soap and water.

J)Turn on the cylinder valve.

K)Check for leaks by wetting the fitting with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.

If there is a leak, turn off the gas and tighten the fitting. Turn the gas back on and recheck with the soap and water solution.

If leak does not stop, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. Do not use the barbecue.

L)When leak checking is complete, turn gas supply OFF at the source and rinse connections with water.

1

2

a

b

10

Image 10
Contents GAS Grill Wash hands after handling this product Liquid Propane GAS Units onlyWARRANTY, GARANTÍA, Garantie USAExploded View Lista DEL Diagrama DE DESPIECE, Liste DE LA Vision Éclatée Exploded View ListGenesis320LPUS2010 Side Burner Table General Instructions For Installation in CanadaCleaning Operating Storage AND/OR NonuseImportant LP Cylinder Information Connecting the Liquid Propane CylinderGAS Instructions Leak Check PreparationTo connect the hose to the cylinder Remove Control Knobs & Control Panel for Leak Testing Check for GAS LeaksRefilling the Liquid Propane Cylinder Checking the Fuel Level in Your TankCanada Operating InstructionsSafe Handling Tips for Liquid Propane GAS Cylinders LightingTo Extinguish Main Burner LightingMain Burner Manual Lighting Lighting the Side Burner To Extinguish320 Manually Lighting the Side BurnerSide Burner Troubleshooting TroubleshootingProblem Check Cure Side Burner Maintenance Side Burner MaintenanceMaintenance Weber SPIDER/INSECT ScreensInspection and Cleaning of the SPIDER/INSECT Screens Annual MaintenanceMain Burner Cleaning Procedure Burner Flame PatternReplace Battery if Necessary Crossover Ignition System OperationsPage Page Barbacoa DE GAS Advertencias PeligroÚnicamente Unidades DE GAS Propano Licuado Instrucciones Generales Preparativos Para LA Búsqueda DE Fugas Instrucciones Sobre EL GASCómo Conectar EL Cilindro DE Propano Licuado Para Conectar LA Manguera AL Cilindro Compruebe QUE no Haya Fugas DE GAS Peligro Usted necesitará un destornillador PhillipsCómo Recargar EL Cilindro DE Propano Licuado Cómo Verificar EL Nivel DE Combustible EN SU TanqueEN Canadá Instrucciones DE OperaciónEncendido Encendido Manual DEL Quemador Principal Peligro Encendido DEL Quemador PrincipalPara Apagar Cómo Encender EL Quemador Lateral Peligro Encendido Manual DEL Quemador Lateral Peligro Resolución DE Problemas DEL Quemador Lateral Resolución DE ProblemasProblema Revisar Remedio Mantenimiento DEL Quemador Lateral Mantenimiento DEL Quemador LateralMantenimiento Mallas Weber Contra Arañas E InsectosProcedimiento Para LA Limpieza DEL Quemador Principal Mantenimiento AnualPatrón DE LA Llama DEL Quemador Reemplazo DE LOS Quemadores PrincipalesOperación DEL Sistema DE Encendido Crossover Reemplace LA Batería SI Fuese NecesarioPage Grill a GAZ Mises EN Garde Mises EN GardeAppareils a GAZ Propane Uniquement Generalites Preparation DE LA Detection DES Fuites Instructions Relatives AU GAZInformations Importantes Relatives a LA Bouteille DE PL Verifiez QUE Toutes LES Valves DES Bruleurs Sont FermeesPour connecter le tuyau à la bouteille de gaz Detection DES Fuites DE GAZ Il vous faudra un tournevis cruciformeRechargement DE LA Bouteille DE Propane Liquide Aiguilles d’une montre, à la main uniquementExigences Relatives À LA Bouteille DE Propane Liquide Instructions Relatives a L’UTILISATIONBouteilles DE GAZ Propane Liquide PL AU CanadaAllumage Manuel DU Bruleur Principal Allumage DU Bruleur PrincipalPour Eteindre Allumage DU Bruleur Lateral Pour EteindreAllumage Manuel DU Bruleur Lateral Depannage Probleme Verification SolutionDepannage DU Bruleur Lateral Maintenance DU Bruleur Lateral Maintenance DU Bruleur LateralGrilles ANTI-ARAIGNEES/INSECTES Weber Remplacement DES Bruleurs Principaux Maintenance AnnuelleProcedure DE Nettoyage DU Bruleur Principal Aspect DES Flammes DU BrûleurOperations DU Systeme D’ALLUMAGE Crossover Remplacez LA Pile SI NecessairePage Page WEBER-STEPHEN Products CO