Weber 89478 manual Remove Control Knobs & Control Panel for Leak Testing, Check for GAS Leaks

Page 11

GAS INSTRUCTIONS

REMOVE CONTROL KNOBS & CONTROL PANEL FOR LEAK TESTING

You will need: Phillips screwdriver.

A)Remove control knobs (1).

B)Remove screw and washer from back of control panel with a Phillips screwdriver

(2).

C)Tilt the back edge of the control panel up. Push in on the front edge to release locking tabs. Carefully pull control panel away from frame (3).

D)Disconnect the igniter wires from the ignition module (4).

E)Replace control panel when Leak Check is completed (5).

CHECK FOR GAS LEAKS

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

Note: All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame-tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber® Gas Barbecue. Shipping and handling may loosen or damage a gas fitting.

WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution, and a rag or brush to apply it.

Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

If your grill has a side burner make sure the side burner is off.

To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise.

WARNING: Do not ignite burners when leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.

Check:

A)Hose-to-manifold connection (1).

WARNING: If there is a leak at connection (1), retighten the fitting with a wrench and recheck for leaks with soap and water solution. If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site.

Log onto www.weber.com®.

B)Regulator-to-cylinder connection (2).

C)The hose-to-regulator connection (3).

D)Valves-to-manifold connections (4).

WARNING: If there is a leak at connections (2), (3) or (4), turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site.

Log onto www.weber.com®.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

1

2

3

5

4

310

1

* The grill illustrated may have slight differences than the model purchased.

2

3

4

WWW.WEBER.COM® 11

Image 11
Contents GAS Grill Liquid Propane GAS Units only Wash hands after handling this productUSA WARRANTY, GARANTÍA, GarantieExploded View Exploded View List Lista DEL Diagrama DE DESPIECE, Liste DE LA Vision ÉclatéeGenesis320LPUS2010 Side Burner Table Operating Storage AND/OR Nonuse For Installation in CanadaCleaning General InstructionsLeak Check Preparation Connecting the Liquid Propane CylinderGAS Instructions Important LP Cylinder InformationTo connect the hose to the cylinder Check for GAS Leaks Remove Control Knobs & Control Panel for Leak TestingChecking the Fuel Level in Your Tank Refilling the Liquid Propane CylinderLighting Operating InstructionsSafe Handling Tips for Liquid Propane GAS Cylinders CanadaMain Burner Manual Lighting Main Burner LightingTo Extinguish To Extinguish Lighting the Side BurnerManually Lighting the Side Burner 320Problem Check Cure TroubleshootingSide Burner Troubleshooting Weber SPIDER/INSECT Screens Side Burner MaintenanceMaintenance Side Burner MaintenanceBurner Flame Pattern Annual MaintenanceMain Burner Cleaning Procedure Inspection and Cleaning of the SPIDER/INSECT ScreensCrossover Ignition System Operations Replace Battery if NecessaryPage Page Barbacoa DE GAS Únicamente Unidades DE GAS Propano Licuado PeligroAdvertencias Instrucciones Generales Cómo Conectar EL Cilindro DE Propano Licuado Instrucciones Sobre EL GASPreparativos Para LA Búsqueda DE Fugas Para Conectar LA Manguera AL Cilindro Usted necesitará un destornillador Phillips Compruebe QUE no Haya Fugas DE GAS PeligroCómo Verificar EL Nivel DE Combustible EN SU Tanque Cómo Recargar EL Cilindro DE Propano LicuadoEncendido Instrucciones DE OperaciónEN Canadá Para Apagar Encendido DEL Quemador PrincipalEncendido Manual DEL Quemador Principal Peligro Cómo Encender EL Quemador Lateral Peligro Encendido Manual DEL Quemador Lateral Peligro Problema Revisar Remedio Resolución DE ProblemasResolución DE Problemas DEL Quemador Lateral Mallas Weber Contra Arañas E Insectos Mantenimiento DEL Quemador LateralMantenimiento Mantenimiento DEL Quemador LateralReemplazo DE LOS Quemadores Principales Mantenimiento AnualPatrón DE LA Llama DEL Quemador Procedimiento Para LA Limpieza DEL Quemador PrincipalReemplace LA Batería SI Fuese Necesario Operación DEL Sistema DE Encendido CrossoverPage Grill a GAZ Appareils a GAZ Propane Uniquement Mises EN GardeMises EN Garde Generalites Verifiez QUE Toutes LES Valves DES Bruleurs Sont Fermees Instructions Relatives AU GAZInformations Importantes Relatives a LA Bouteille DE PL Preparation DE LA Detection DES FuitesPour connecter le tuyau à la bouteille de gaz Il vous faudra un tournevis cruciforme Detection DES Fuites DE GAZAiguilles d’une montre, à la main uniquement Rechargement DE LA Bouteille DE Propane LiquideAU Canada Instructions Relatives a L’UTILISATIONBouteilles DE GAZ Propane Liquide PL Exigences Relatives À LA Bouteille DE Propane LiquidePour Eteindre Allumage DU Bruleur PrincipalAllumage Manuel DU Bruleur Principal Pour Eteindre Allumage DU Bruleur LateralAllumage Manuel DU Bruleur Lateral Depannage DU Bruleur Lateral Probleme Verification SolutionDepannage Grilles ANTI-ARAIGNEES/INSECTES Weber Maintenance DU Bruleur LateralMaintenance DU Bruleur Lateral Aspect DES Flammes DU Brûleur Maintenance AnnuelleProcedure DE Nettoyage DU Bruleur Principal Remplacement DES Bruleurs PrincipauxRemplacez LA Pile SI Necessaire Operations DU Systeme D’ALLUMAGE CrossoverPage Page WEBER-STEPHEN Products CO