| MAINTENANCE | 19 |
4) | Loosen the two nuts (a) that hold the manifold to the cooking box. Pull the |
|
| manifold and valve assembly out of the burners (b) and carefully set it down. |
|
|
| a |
|
| b |
5) | Slide the burner assembly out from under the guide screw and washer (a) in the |
|
| corners of the cooking box. |
|
6) | Lift and twist the burner assembly slightly, to separate the crossover tube (b) from | a |
| the burners. Remove the burners from the cooking box. |
|
7) | To reinstall the burners, reverse 3) through 7). |
|
CAUTION: The burner openings (c) must be positioned properly over the valve orifices (d).
Check proper assembly before fastening manifold in place.
WARNING: After reinstalling the gas lines, they should be |
|
leak checked with a soap and water solution before using |
|
the barbecue. (See Step: “Check for gas leaks.”) | b |
c
d
CROSSOVER® IGNITION SYSTEM OPERATIONS
If The Crossover® Ignition System fails to ignite the BURNER 1, light BURNER 1 with a match. If BURNER 1 lights with a match, then check the Electronic Ignition System.
• Check that both of the ignition wires are attached properly.
• Check that the Electronic Ignition Button is working by listening and looking for sparks at BURNER 1.
REPLACE BATTERY IF NECESSARY
AAA alkaline battery only. See illustration:
If the Electronic Ignition System still fails to light, contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.
WWW.WEBER.COM®