Weber 300 manual Burner Tube Cleaning, Burner Tube Reinstallation

MAINTENANCE

Burner Tube Cleaning

mCAUTION: Care must be taken when removing or

reinstalling burner tubes. Do not force or bend the gas lines that connect the burner tubes to the control valve.

G) Look inside each burner with a flashlight.

H) Clean the inside of the burners with a wire (a straightened-out coat hanger will work).

I)Check and clean the air shutter opening at the ends of the burners. Check and

clean the valve orifices at the base of the burner orifice (3). Use a steel bristle brush to clean outside of burners. This is to make sure all the burner ports are fully open.

mCAUTION: Do not enlarge the burner ports when cleaning.

J)Lightly tap the burner to get debris and dirt out of the burner tube. Once the Spider/ Insect screen and burner is clean reinstall the burner.

Burner Tube Reinstallation

mCAUTION: The burner opening (4) must be positioned properly over the valve orifices (5).

K)To reinstall the burner, reverse D) through F). Check for proper assembly before fastening burner tubes in place.

mWARNING: After reinstalling the burners, the gas connections should be leak checked with a soap and water solution before using the barbecue. Refer to “CHECK FOR GAS LEAKS”.◆

45

3

4

3

34