Weber 300 manual Troubleshooting, Problem Check Solution

Page 31

TROUBLESHOOTING

PROBLEM

CHECK

SOLUTION

 

 

 

Burners burn with a yellow or

Inspect Spider / Insect screens for possible obstructions.

Clean Spider/Insect screens. Refer to “ANNUAL MAINTENANCE”.

orange flame, in conjunction with

(Blockage of holes.)

 

the smell of gas.

 

 

 

 

 

Symptoms:

The excess flow safety device, which is part of the barbecue to

To reset the excess flow safety device turn all burner control

Burners do not ignite. -or- Burners

cylinder connection, may have activated.

knobs and the cylinder valve off. Disconnect the regulator from the

 

cylinder. Turn burner control knobs to HI. Wait at least 1 minute.

have a small flickering flame in the

 

 

Turn burner control knobs to OFF. Reconnect the regulator to the

HI position. -or-

 

 

cylinder. Turn cylinder valve on slowly. Refer to “IGNITION”.

 

 

Barbecue temperature only reaches

 

 

250° to 300° in the HI position.

 

 

 

 

 

Burner does not light, or flame is

Is LP fuel low or empty?

Refill LP cylinder.

low in HI position.

 

 

Is fuel hose bent or kinked?

Straighten fuel hose.

 

 

 

 

 

Does the outside burner light with a match?

If you can light the outside burner with a match, then check the

 

 

ignition system.

 

 

 

Burner does not ignite when you

Be sure that there is gas flow to the burners by attempting to

If match lighting is successful, the problem lies in the ignition

push the igniter button.

match light your burners. Refer to “MANUAL IGNITION”.

system. Refer to “MAINTENANCE”.

 

 

 

 

Is there is a fresh battery installed?

Verify that the battery is in good condition and installed correctly.

 

 

Refer to “BEFORE USING THE BARBECUE”.

 

 

 

 

Are the wires connected properly to the ignition box?

Be sure that wires are correctly inserted into terminals on ignition

 

 

box. Refer to “MAINTENANCE.

 

 

 

 

Is there plastic wrapping around the new battery?

Remove plastic wrapping.

 

 

 

 

Is burner tube positioned too far away from the igniter electrode?

Check that the burner tube is positioned correctly to the igniter

 

 

electrode. Refer to “MAINTENANCE”.

 

 

 

Experiencing flare-ups:

Are you preheating barbecue in the prescribed manner?

All burners on HI for 10 to 15 minutes for preheating.

m CAUTION: Do not

 

 

Are the cooking grates heavily coated with burned-on grease?

Clean thoroughly. Refer to “CLEANING”.

line the cookbox with

 

 

Is the cookbox dirty and not allowing grease to flow into catch

Clean cookbox.

aluminum foil.

pan?

 

 

 

 

Burner flame pattern is erratic.

Are burners clean?

Clean burners. Refer to “MAINTENANCE”.

Flame is low when burner is on

 

 

HIGH. Flames do not run the whole

 

 

length of the burner tube.

 

 

 

 

 

Inside of lid appears to be “peeling.”

The inside of the lid is Cast Aluminum, and is not painted. It cannot

Clean thoroughly. Refer to “CLEANING”.

(Resembles paint peeling.)

“peel”. What you are seeing is baked on grease that has turned to

 

 

carbon and is flaking off.

 

 

THIS IS NOT A DEFECT.

 

 

 

 

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

www.weber.com® 31

Image 31
Contents GAS Grill Liquid Propane GAS Units only Table of Contents Q300USLP072710 Rear Cradle Soporte posterior Berceau arrière Cookbox Valve & Manifold Regulator AssemblyQ320USLP072710 Rear Cradle Soporte posterior Socle arrière Cookbox Ignition Button/ Ignition Module Perilla de control grandeLid Warming RackScrew Black Parts LIST, Lista DE PIEZAS, Liste DES PiècesWood Block Phillips Screw Black Truss HeadASSEMBLY, ENSAMBLAJE, Assemblage ASSEMBLY, ENSAMBLAJE, Assemblage ASSEMBLY, ENSAMBLAJE, Assemblage ASSEMBLY, ENSAMBLAJE, Assemblage ASSEMBLY, ENSAMBLAJE, Assemblage ASSEMBLY, ENSAMBLAJE, Assemblage ASSEMBLY, ENSAMBLAJE, Assemblage Au pied du chariot ASSEMBLY, ENSAMBLAJE, Assemblage ASSEMBLY, ENSAMBLAJE, Assemblage 17 Q320 18 Q320 19 Q320 20 Q320 General Instructions WarrantyOperating Mount The Cylinder GAS InstructionsStorage AND/OR NON-USE Important LP Cylinder InformationCheck That The Burner Valves Are Off Liquid Propane Cylinder ConnectionHose to Cylinder Connection Check for GAS LeaksCheck Safe Handling Tips for Liquid Propane GAS Cylinders Refilling the Liquid Propane CylinderHose Inspection Before Using the BarbecueCatch PAN and Disposable Drip PAN Igniter Inspection for Models with Electronic IgnitionIgnition Ignition & UsageTo Extinguish Manual Ignition Grilling Tips & Helpful Hints Cooking MethodsPreheating the Barbecue Cooking Problem Check Solution TroubleshootingMaintenance Handle Light Troubleshooting Q320Cleaning Weber SPIDER/INSECT Screens Burner Tube Cleaning or ReplacementBurner Tube Removal Burner Tube Reinstallation Burner Tube CleaningElectronic Ignition System Operations PUSH-BUTTON Ignition System OperationsInspection And Cleaning Of The Spider/Insect Screen Annual MaintenanceMain Burner Flame Pattern Barbacoa DE GAS Únicamente Unidades DE GAS Propano Licuado AdvertenciasTabla DE Contenido Resolución DE Problema DE LA Lámpara DE ASA Q320Instrucciones Generales GarantíaOperación Monte el cilindro Instrucciones Sobre EL GASAlmacenaje Y/O Fuera DE USO Información Importante Sobre EL Cilindro DE Propano LicuadoConexión DE LA Manguera AL Cilindro Conexión DEL Cilindro DE Propano LicuadoRevisión DE Detección DE Fugas DE GAS Verificar Requisitos de los cilindros de propano licuado Rellenado DEL Cilindro DE Propano LicuadoCómo retirar el cilindro de gas propano licuado Cilindros de propano licuadoPlato Recolector Y Bandeja DE Goteo Desechable Antes DE Utilizar LA BarbacoaInspección DE LA Manguera Encendido Encendido Y USOPara Apagar Encendido Manual Cocción Métodos DE CocciónConsejos Prácticos Para Asar Precalentamiento DE LA BarbacoaProblema Revisar Solución Resolución DE ProblemasMantenimiento Resolución DE Problemas DE LA Lámpara DE ASA Q320Limpieza Limpieza O Reemplazo DE LOS Tubos DEL Quemador Weber Mallas Contra Arañas E InsectosRetiro de los tubos del quemador Reinstalación del tubo del quemador Limpieza del tubo del quemadorOperaciones CON EL Sistema Electrónico DE Encendido Operaciones DEL Sistema DE Encendido CON Botón DE OprimirInspección y limpieza de la malla contra arañas e insectos Mantenimiento AnualPatrón de la llama del quemador principal Grill a GAZ Appareils a GAZ Propane Uniquement Mises EN GardeMises EN Garde Table DES MatieresGeneralites GarantieUtilisation Montez la bouteille Instructions Relatives AU GAZStockage ET/OU Inutilisation Informations Importantes Concernant LA Bouteille DE PLVérifier que les valves du brûleur sont fermées Connexion DE LA Bouteille DE Propane LiquideConnexion Entre LE Tuyau ET LA Bouteille DE GAZ Detecter LES Fuites DE GAZVérifiez Mise EN Garde en cas de fuite, fermez le gaz et serrez leExigences concernant la bouteille de propane liquide Recharger LA Bouteille DE Propane LiquideRetrait de la bouteille de PL Bouteilles de Propane liquide PLEgouttoir ET Egouttoir Jetable Avant D’UTILISER LE BarbecueInspection DU Tuyau Allumage Allumage & UtilisationPour Eteindre Allumage Manuel Cuisson Methodes DE CuissonConseils & Astuces Pour LA Grillade Prechauffer LE BarbecueDepannage Probleme Verification SolutionNettoyage Depannage DE L’ECLAIRAGE DE Poignee Q320Grilles ANTI-ARAIGNEES/INSECTES Weber Nettoyage OU Remplacement DU Tube DU BruleurRetrait du tube du brûleur Nettoyage du tube du brûleur Réinstallation du tube du brûleurUtilisation DU Systeme D’ALLUMAGE Electronique Operations DU Dispositif D’ALLUMAGEFermee Aspect de la flamme du brûleur principal Maintenance Annuelle