Invacare 9000 XDT Adjusting Seat Width, SL with Adjustable Back Angle Option and 9000 XT/XDT

SECTION 3—SEAT AND BACK

9000 SL with Adjustable Back Angle Option and 9000 XT/XDT

NOTE: For this procedure, refer to FIGURE 3.3.

1.Remove the two (2) mounting screws, spacers and locknuts that secure the two (2) back canes to the wheelchair frame (Detail “A”).

2.Reposition the back canes to one (1) of five (5) height adjustment positions (Detail “B”):

HOLE NUMBER	1 & 2	2 & 3	3 & 4	4 & 5	5 & 6
BACK HEIGHT	15 in.	16 in.	17 in.	18 in.	19 in.

NOTE: Holes are numbered from bottom to top for reference only. There are no numbers on the back canes.

3.Reinstall the two (2) mounting screws, spacers and locknuts that secure the back canes to the wheelchair frame and securely tighten.

NOTE: The spacers must be on the outside of the wheelchair in order to properly tighten the mounting screws.

DETAIL “A”

Back Cane

Wheelchair

Frame

SpacersLocknuts

Mounting Screws

DETAIL “B”

Back Cane

	Hole
Height	6
	5
Adjustment
	4
Positions	3	Wheelchair
	2	Frame
	1

FIGURE 3.3 Adjusting Back Height - 9000 SL with Adjustable Back Angle Option and 9000

XT/XDT

Adjusting Seat Width

NOTE: For this procedure, refer to FIGURE 3.4.

NOTE: When adjusting the seat width of the wheelchair, the back and seat upholstery MUST be changed. If applicable, the headrest pillow and headrest upholstery MUST be changed as well.

1.Remove the existing back and seat upholstery from the wheelchair. Refer to Replacing the Back Upholstery and Replacing the Seat Upholstery in the ownerʹs manual, part number 1056953.

9000 Series 20 Part No. 1076155