Invacare 9000 Series, 9000 XT, 9000 XDT Chart 9 Seat-to-Floor Height of 17½ inches and 0 Angle

SECTION 5—SEAT TO FLOOR

24-Inch Rear Wheels and 6-Inch Front Casters

WARNING

If changing the seat-to-floor angle to 6°, anti-tippers MUST be installed.

Refer to the following table to determine the obtainable seat‐to‐floor heights and seat‐to‐floor angles for 24‐inch rear wheels and 6‐inch front casters:

SEAT-TO-FLOOR	SEAT-TO-FLOOR	REFER TO
HEIGHT*	ANGLE
17½ inches	0°	Chart 9
17½ inches	3°	Chart 10
17½ inches	6°	Chart 11
16½ inches	0°	Chart 12
16½ inches	3°	Chart 13
15½ inches	0°	Chart 14

*NOTE: The seat‐to‐floor heights are based on urethane tires. If wheelchair is equipped with pneumatic (properly inflated) or solid rubber tires, add ¼ inch to the measurements listed above. These heights can vary +/‐ ¼ inch due to tire wear and manufacturing tolerances.

NOTE: Charts 9 to 14 apply to adult/hemi frame styles only. Refer to the charts for seat‐to‐floor height settings for adult/tall (Adult/Tall Frame Style on page 31) and super low frame styles (Super Low Frame Style on page 31) and Changing Seat‐to‐Floor Height on page 77 for recliner frame styles.

Chart 9 - Seat-to-Floor Height of 17½ inches and 0° Angle

REAR WHEEL POSITION			ANTI-TIP	FRONT CASTER
OFFSET AXLE OPTION		STANDARD	PART/MODEL	MOUNTING	ADJC CAM
FORWARD	REARWARD		NUMBERS	POSITION	POSITION
Hole 4	Hole 4	N/A for this	N/A On-Chair		Front
		frame style
			1058836
Hole 2			Off-Chair
	Hole 2
					Notch

Part No. 1076155 37 9000 Series