Invacare 9000 SL, 9000 XT Seat to Floor, Changing Seat-to-Floor Height/Seat-to-Floor Angle

SECTION 5—SEAT TO FLOOR

SECTION 5—SEAT TO FLOOR

WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise, injury or damage may occur.

Changing Seat-to-Floor Height/Seat-to-Floor Angle

WARNING

Before performing this procedure, refer to Stability - All Models on page 12 for additional requirements.

DO NOT deviate from the charts on the following pages. If the restrictions for seat-to-floor heights and seat-to-floor angles are not followed, the wheelchair will be in an unsafe position. Before changing these settings, refer to the following charts for the allowable positions.

NOTE: For this procedure, refer to FIGURE 5.1.

NOTE: This section is for non‐recliner wheelchairs only. For recliners, refer to Changing Seat‐to‐Floor Height on page 77.

NOTE: Seat‐to‐floor angle adjustments are only available on 9000 XT with the offset axle option and adjustable caster journal (ADJC). All other models/options have a 3° seat‐to‐floor angle.

The different Seat‐to‐Floor heights and angles (Detail “A”) are possible by using different combinations of rear wheels, rear wheel positions, front caster positions, front caster size and cam positions.

1.Determine the model and frame style of your wheelchair. Refer to the following chart and FIGURE 5.1.

	MODEL		FRAME STYLE
		Adult/Hemi	Adult/Tall	Super Low
9000	SL	X	N/A	N/A
9000 XT		X	N/A	X
9000	XT with Bolt-on-Headtube (ADJC)	X	N/A	N/A
9000 XDT		N/A	X	N/A

Part No. 1076155 29 9000 Series