SECTION
•If there is too much play in the release handle:
i.Rotate the jam nut clockwise (downward) two (2) to three (3) revolutions.
ii.Rotate the swivel nut counterclockwise (upward) one (1) revolution.
iii.Rotate the jam nut counterclockwise (upward) directly underneath the swivel nut. Securely tighten.
iv.Squeeze the release handle and note the amount of play. If necessary, repeat this procedure until the play in the release handle is at minimum.
•If there is not enough play in the release handle:
i.Rotate the jam nut clockwise (downward) two (2) to three (3) revolutions.
ii.Rotate the swivel nut clockwise (downward) one (1) revolution.
iii.Rotate the jam nut counterclockwise (upward) directly underneath the swivel nut. Securely tighten.
iv.Squeeze release handle and note the amount of play. If necessary, repeat this procedure until slight play in the release handle occurs.
Release |
|
Handle | Swivel Nut |
|
Jam Nut
Back Tube
Mounting
Bracket
Seven (7)
Threads
Cable
Assembly
FIGURE 7.2 Adjusting Cable Assembly Tension
Replacing Cable Assembly
NOTE: For this procedure, refer to FIGURE 7.3.
1.Cut the tie‐wraps that secure the cable assembly to the back tube.
2.Remove the release handle. Refer to Replacing Release Handle on page 58.
3.Disconnect the existing lower cable assembly. Refer to Disconnecting/Connecting Lower Cable Assembly on page 61.
9000 Series | 60 | Part No. 1076155 |