Invacare 9000 XDT, 9000 XT, 9000 Series Chart 31 Seat-to-Floor Height of 17½ inches and 6 Angle

SECTION 5—SEAT TO FLOOR

Chart 31 - Seat-to-Floor Height of 17½ inches and 6° Angle

REAR WHEEL POSITION			ANTI-TIP	FRONT CASTER
			PART/MODEL
OFFSET AXLE OPTION		STANDARD		MOUNTING	ADJC CAM
			NUMBERS	POSITION	POSITION
FORWARD	REARWARD
Hole 4	Hole 4	N/A for this	N/A On-Chair		Front
		frame style

1113766 Off-Chair

Hole 2

Hole 2

Notch

20-Inch Rear Wheels and 6-Inch Front Casters

WARNING

If changing the seat-to-floor angle to 6°, anti-tippers MUST be installed.

Refer to the following table to determine the obtainable seat‐to‐floor heights and seat‐to‐floor angles for 20‐inch rear wheels and 6‐inch front casters:

SEAT-TO-FLOOR	SEAT-TO-FLOOR	REFER TO
HEIGHT*	ANGLE
17½ inches	3°	Chart 32
17½ inches	6°	Chart 33
16½ inches	0°	Chart 34
16½ inches	3°	Chart 35
16½ inches	6°	Chart 36
15½ inches	0°	Chart 37
15½ inches	3°	Chart 38
15½ inches	6°	Chart 39

*NOTE: The seat‐to‐floor heights are based on urethane tires. If wheelchair is equipped with pneumatic (properly inflated) or solid rubber tires, add ¼ inch to the measurements listed above. These heights can vary +/‐ ¼ inch due to tire wear and manufacturing tolerances.

NOTE: Charts 32 to 39 apply to adult/hemi frame styles only. Refer to the charts for seat‐to‐floor height settings for adult/tall (Adult/Tall Frame Style on page 31) and super low frame styles (Super Low Frame Style on page 31) and Changing Seat‐to‐Floor Height on page 77 for recliner frame styles.

9000 Series 48 Part No. 1076155