Invacare 9000XT Recliner, 9000 XT, 9000 Series, 9000 XDT, 9000 SL service manual Pivot Link

SECTION 3—SEAT AND BACK

2.Remove the four (4) button screws and locknuts that secure the two (2) pivot links to the wheelchair frame and crossbraces.

3.Remove the two (2) button screws, locknuts and crossbrace saddle that secures the bottom of the crossbrace to the wheelchair frame. Repeat for other crossbrace.

4.Remove the hex screw, coved washers, washers and locknut that secure the two (2) crossbraces together. See Detail ʺBʺ of FIGURE 3.4.

NOTE: Make note of the orientation of the coved washers, washers and locknut for assembling the new crossbraces. Refer to Detail ʺBʺ of FIGURE 3.4.

5.Assemble the two (2) new crossbraces together with the existing hex screw, coved washers, washers and locknut. Securely tighten. Refer to Detail ʺBʺ of FIGURE 3.4 for hardware orientation.

6.Determine the correct pivot link and mounting hole to use with the desired seat width. Refer to the following chart.

SEAT WIDTH	PIVOT LINK
14-INCH
15-INCH	14-Inch	15-Inch
*16-INCH	16-Inch	18-Inch
		x
*18-INCH
	DO NOT use
*20-INCH	20-Inch
22-INCH
	22-Inch

*NOTE: 16, 18, and 20‐inch are the only crossbrace settings available on the 9000 SL.

7.Secure the pivot link to the crossbraces and wheelchair frame with the four (4) button screws and locknuts. Securely tighten.

NOTE: Position crossbrace saddle on wheelchair frame using the washer on the underside of the wheelchair frame as a reference. Refer to Detail ʺAʺ of FIGURE 3.4 for proper positioning of the crossbrace saddle.

8.Reinstall the two (2) button screws, locknuts and crossbrace saddle that secure the bottom of the new crossbrace to the wheelchair frame. Refer to Detail ʺBʺ of FIGURE 3.4 for hardware orientation. Repeat for opposite crossbrace. Securely tighten.

9.Install the new back and seat upholstery onto the wheelchair. Refer to Replacing Back Upholstery and Replacing Seat Upholstery in the ownerʹs manual, part number 1056953.

Part No. 1076155 21 9000 Series