Invacare 9000 XT, 9000XT Recliner Using/Adjusting Wheel Locks, With Patient Operated Wheel Locks

SECTION 7—RECLINER

Removing/Installing Rear Wheels

With Patient Operated Wheel Locks

NOTE: For this procedure, refer to FIGURE 7.12.

Wheelchair Frame	Patient Operated
	Wheel Lock
Locknut	Axle
	Mounting
	Screw

1.Remove the axle mounting screw and locknut that secure the patient operated wheel lock, spacers, and rear wheel to the wheelchair frame.

2.Secure rear wheel, patient operated wheel lock, and spacers to wheelchair frame with axle mounting screw and locknut. Torque locknut to 40‐50 ft./lbs.

Spacers

Rear

Wheel

FIGURE 7.12 Removing/Installing Rear

Wheels - With Patient Operated Wheel

Locks

With Attendant Operated Wheel Locks

NOTE: For this procedure, refer to FIGURE 7.13.

1.Remove the axle mounting screw and locknut that secure the rear wheel and spacer to the wheelchair frame.

2.Remove rear wheel from side frame.

3.Secure rear wheel and spacer to wheelchair frame with axle mounting screw and locknut. Torque locknut to 40‐50 ft./lbs.

Axle	Wheelchair Frame	Locknut
Mounting
Screw

Spacer

Rear

Wheel

FIGURE 7.13 Removing/Installing Rear

Wheels - With Attendant Operated Wheel

Locks

Using/Adjusting Wheel Locks

NOTE: For Using and/or Adjusting of Patient Operated Wheel Locks, refer to Using/Adjusting Disk Wheel Locks on page 82.

Using Attendant Operated Wheel Locks

WARNING

DO NOT attempt to stop a moving wheelchair with wheel locks. Wheel locks are not brakes.

Part No. 1076155 75 9000 Series