A&D HW-100KGL, HG-60KGV, HW-60KGL, HW-200KGL, HW-200KGV, HW-10KGV, HW100KGV, HW-10KGL HW-G Ozim v1a

Display and Symbols Meaning

Example:- Display of the counting mode.

This mode uses the registered unit mass, counts the quantity of articles on the pan. The unit is PCS.

Example:- Storing the unit mass in the counting mode. This is a display of zero point for counting mode and uses 20 pieces for the unit mass registration.

Example:- Storing the unit mass in the counting mode.

Sign “-” means “weighing value is not zero”.

Sample number is 10 pieces.

Example:- Percentage mode.

This mode uses the registered 100% mass, converts the weighing value to a percentage. The unit is % .

Example:- Display of the function table.

This function table sets parameters of items.

< switch	Selecting an item.
^ switch	Selecting a parameter of the item.

ENTER switch Storing new parameters.

Example:-. Preset tare. Entering tare with digital input.

< switch	Selecting a figure.
^ switch	Selecting a number.

ENTER switch Storing new tare.

Example:- Hold display

The hold display is set using f12 of the function table. When weighing value is “near-zero” or changes more than 25% +30 digits, the hold is cancelled.

Overload display.

Remove everything from the pan.

Weighing error.

Check the base unit and weighing pan.

Calibration error.

Means “Calibration mass is too light”.

Check the base unit and weighing pan.

HW-G OZIM v1a

HW-G Instruction Manual Page 14