A&D HG-60KGV, HW-100KGL, HW-60KGL, HW-200KGL, HW-200KGV, HW-10KGV Preparation Setting Parameters

Page 57

16.4 Preparation (Setting Parameters)

Step 1 Turn off the display.

Press the ON/OFF switch while the ZERO switch is pressed and held. The function table is displayed.

Step 2

Select a parameter of the “baud rate ( f4 )” using

 

the

 

and ^ switches.

 

ENTER

Step 3 Select “command mode ( f5 1 )” of the “output” using the ENTER and^ switches.

Step 4 Select “format 1 ( f15 0 )” of the “format” using the ENTER and ^ switches.

Step 5 Press the ENTER switch to store the new parameters.

Return to the normal weighing mode using the

ENTER switch.

Step 6 Receiving a command, the scale responds.

HW-G Instruction Manual Page 55

HW-G OZIM v1a

Image 57
Contents HW-G Series Page Contents HW-G Ozim v1a Compliance with FCC rules ComplianceOutline and Features Unpacking All AccessoriesType Products Accessories Accessories and Options listOptions List Order code or option name AccessoriesPrecautions for Installing the Scale Precautions for Operating the ScalePrecautions for Storing the Scale Secure the Column Installing the ScaleStpe 3 Secure the Display Unit Fit the PanAdjust the Display Unit Connect the PowerLevel the Scale Installing the Batteries for Type L Names OFF Display and SymbolsHW-G Ozim v1a Switches HW-G Ozim v1a Basic Operation Turning the Scale On/Off & Basic WeighingMemo Type L with Batteries Semi-Automatic Tare Input by Weighing Tare and Net DisplayMode Switch Changing Unit & Mode Storing a Unit Mass Counting ModeCounting the number of articles Storing a 100% Mass Percentage ModeReading Percentage Operation and Switches Accumulation FunctionFunction table Meaning & Purpose Preparation Setting Parameters Example Operation and Performance ExamplesComparator Sign Comparator FunctionComparison Condition Function table Meaning and PurposeSwitch to display an item Step If one Has Been selected, press Case Full/Dribble Batch Function Comparator Full/Dribble batch sub-functionHold Parameter and display an item of the full/dribble Switch to display the HI Function Table Meaning and purpose Simple batch function Simple Batch FunctionPreparation Setting Parameters Mode Calibration Adjusting the Scale Gravity Acceleration Table Gravity Acceleration Correction Complete Calibration ProcedureCalibration of the Zero Point Function Table Procedure for Setting Parameters15.2 Parameter List Function or full/dribble batch function Display Meaning and purposePrinting condition when using option OP-06 for type Function to hold the current display value. When 16 RS-232C Serial Data Interface Format Data FormatFormat Preparation and Performance Examples Stream ModeCommand Mode Cancel of tareTare Upper limit value Preset tareFinal value Preparation Setting Parameters Pin connections Pin No Signal name Direction Description Options17.1 RS-232C / Relay output / Buzzer OP-03 17.2 RS-422 / RS-485 / Relay output OP-04 Pin No Signal name Direction DescriptionInstalling OP-04 Communication Format Lower limit value ZeroAccumulation data output Reset of Accumulation data and numberAccumulation count output Final valueSpecification Internal Printer for Type V OP-06Consumables Installation DisassemblyPerformance Check HW-GV HW-G seriesDimensions HW-G Ozim v1a Check Points Before Calling Maintenance MaintenanceRepair This situation Confirm these items