A&D HW-10KGL, HW-100KGL Display Meaning and purpose, Function or full/dribble batch function

Item	Display				Meaning and purpose
Comparator				When the display value becomes stable after pressing the
					switch, the scale compares the display value. It does not
				SET
	f6	4		compare on an unstable condition. If the					switch is pressed
								SET
				again, the scale stops the comparison.
				When the display value becomes stable, the scale compares
	f6	5		the display value. It does not compare on an unstable
				condition.
				When the display value becomes stable and not near-zero
				after pressing the			switch, the scale compares the display
						SET
	f6	6		value. It does not compare on an unstable condition. If the
										SET
				switch is pressed again, the scale stops the comparison.
	f6	7		When the display value becomes stable when not near-zero,
				the scale compares the value.
	f6	8		Simple batch function. (Refer to section 13.)
	f6	9		Full/dribble batch function. (Refer to section 12.)
Buzzer				The condition of the buzzer on option OP-03 by comparator
				function or full/dribble batch function.
	f7	0	#	No buzzer.
	f7	1		The buzzer sounds at LO.
	f7	2		The buzzer sounds at OK.
	f7	3		The buzzer sounds at LO and OK.
	f7	4		The buzzer sounds at HI.
	f7	5		The buzzer sounds at LO and HI.
	f7	6		The buzzer sounds at OK and HI.
	f7	7		The buzzer sounds at LO, OK and HI.
	f7	8		The buzzer sounds at finishing the full/dribble batch process.
Accumulator				The condition of the accumulator
	f8	0	#	Accumulator is not used.
				The scale accumulates the data, if the F switch is pressed,
	f8	1		when the display becomes a positive stable value above
				near-zero. Next accumulation can be performed after the
				display becomes near-zero or a negative value.
				The scale accumulates the data, if the F switch is pressed,
	f8	2		when the display becomes a stable value outside near-zero.
				Next accumulation can be performed after the display be
				comes near-zero.
				When the display becomes a positive stable value, the scale
	f8	3		accumulates the data automatically. Next accumulation can
				be performed after the display becomes near-zero or a
				nega tive value.

HW-G Instruction Manual Page 45

HW-G OZIM v1a