16.3 Command Mode
The command mode is the function which can perform “output data”, “controlling the scale” and “setting parameters” by a command transmitted from a computer.
Caution Allow at least 500 milliseconds between commands.
16.3.1 Command List
The following explanation uses “format 1 ( f15 0 )”
Data output
The current weighing data is output.
Template Q
Command
Reply
Selection of mode and unit
Selects the mode and unit. This is the same as the MODE
switch.
Template | U | |||||
Command |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| |
Response | The scale changes mode and unit. | |||||
Zero
The current mass value is set to the zero point.
This is same as the ZERO switch.
Template | Z | ||||||
Command |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Response | The mass value becomes zero and zero point mark is displayed. | ||||||
Tare
The current mass value is set to zero after placing a tare (container, receptacle, case, etc) and the net is displayed. This is the same as the TARE switch.
Template | T | ||||||
Command |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Response | The current mass value becomes zero and net mark is displayed. | ||||||
Cancel of tare
The display value becomes the gross and the net mark is turned off. (The tare value becomes zero.)
Template | CT | ||||||
Command |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Response | Gross is displayed and the net mark is turned off. | ||||||