A&D HW-200KGV, HW-100KGL, HG-60KGV, HW-60KGL, HW-200KGL, HW-10KGV, HW100KGV, HW-10KGL Installing OP-04

Page 60

Circuit

Caution

Please confirm that the AC adaptor type is correct for your local voltage and receptacle type.

Selection switch for the RS-422/ RS-485 interface

Selects either of RS-422 or RS-485 interface using a switch on the board.

Installing OP-04

Step 1 Remove two screws that attach the RS232C board on the rear of the display unit. Remove the RS232C board.

Step 2 Switch the connections. Step 3 Insert the option board into the

display unit and afix with the screws

HW-G OZIM v1a

HW-G Instruction Manual Page 58

Image 60
Contents HW-G Series Page Contents HW-G Ozim v1a Compliance Compliance with FCC rulesOutline and Features All Accessories UnpackingAccessories and Options list Type Products AccessoriesOrder code or option name Accessories Options ListPrecautions for Installing the Scale Precautions for Operating the ScalePrecautions for Storing the Scale Installing the Scale Secure the ColumnStpe 3 Secure the Display Unit Fit the PanAdjust the Display Unit Connect the PowerLevel the Scale Installing the Batteries for Type L Names Display and Symbols OFFHW-G Ozim v1a Switches HW-G Ozim v1a Basic Operation Turning the Scale On/Off & Basic WeighingMemo Type L with Batteries Tare and Net Display Semi-Automatic Tare Input by WeighingMode Switch Changing Unit & Mode Counting Mode Storing a Unit MassCounting the number of articles Percentage Mode Storing a 100% MassReading Percentage Operation and Switches Accumulation FunctionFunction table Meaning & Purpose Preparation Setting Parameters Operation and Performance Examples ExampleComparator Function Comparator SignComparison Condition Function table Meaning and PurposeSwitch to display an item Step If one Has Been selected, press Case Full/Dribble Batch Function Comparator Full/Dribble batch sub-functionHold Parameter and display an item of the full/dribble Switch to display the HI Simple Batch Function Function Table Meaning and purpose Simple batch functionPreparation Setting Parameters Mode Calibration Adjusting the Scale Gravity Acceleration Table Complete Calibration Procedure Gravity Acceleration CorrectionCalibration of the Zero Point Procedure for Setting Parameters Function Table15.2 Parameter List Display Meaning and purpose Function or full/dribble batch functionPrinting condition when using option OP-06 for type Function to hold the current display value. When 16 RS-232C Serial Data Interface Data Format FormatFormat Stream Mode Preparation and Performance ExamplesCommand Mode Cancel of tareTare Preset tare Upper limit valueFinal value Preparation Setting Parameters Pin connections Pin No Signal name Direction Description Options17.1 RS-232C / Relay output / Buzzer OP-03 Pin No Signal name Direction Description 17.2 RS-422 / RS-485 / Relay output OP-04Installing OP-04 Communication Format Zero Lower limit valueReset of Accumulation data and number Accumulation data outputAccumulation count output Final valueSpecification Internal Printer for Type V OP-06Consumables Disassembly InstallationPerformance Check HW-G series HW-GVDimensions HW-G Ozim v1a Maintenance Check Points Before Calling MaintenanceRepair This situation Confirm these items