Invacare 1080556 manual Procedure General Guidelines Tipping, Method 1 Wheelchair with Step Tubes

Page 16

GENERAL GUIDELINES

PROCEDURE 1

GENERAL GUIDELINES

TIPPING

WARNING

DO NOT tip the wheelchair without assistance.

When tipping the wheelchair, an assistant should grasp the back of the wheelchair on a non- removable (non-detachable) part. Inform the wheelchair occupant before tipping the wheelchair and remind him/her to lean back. Be sure the occupant’s feet and hands are clear of all wheels and/or pinch points.

After mastering the techniques of tipping the wheelchair, use one (1) of the following methods to tackle curbs, short stairs, etc.

TIPPING - CURBS: METHOD 1 - WHEELCHAIR WITH STEP TUBES:

Place foot on the step tube and begin to tilt the wheelchair toward you. Apply a continuous downward motion until the balance point is achieved and the front casters clear the curb. At this point, the assistant will feel a difference in the weight distribution.

WARNING

When lowering the front casters of the wheelchair, DO NOT let the wheelchair drop the last few inches to the ground. This could result in injury to the occu- pant and/or damage to the wheelchair.

Step Tube

METHOD 1 - WHEELCHAIR WITH STEP TUBES

Roll the wheelchair forward and slowly lower the front of the wheelchair in one continuous movement onto the sidewalk. Do not let the wheelchair drop the last few inches to the ground. This could result in injury to the occupant. Push the wheelchair forward until the rear wheels roll up and over the curb.

TIPPING - CURBS: METHOD 2 - WHEELCHAIR WITHOUT STEP TUBE

This method requires two (2) assistants. The second assistant should be positioned at the front of the wheelchair lifting upward on a non-removable (non-detachable) part of the wheelchair frame when lifting the wheelchair and stabilizing the wheelchair when the wheelchair is being lowered to the ground.

Rotate the anti-tippers so the anti-tip wheels are pointing up. The first assistant should stand on the sidewalk and turn the wheelchair so that the rear wheels are against the curb. The wheelchair should be tilted back to the balance point and, in one continuous upward move- ment, the rear wheels should be pulled up and over the curb. DO NOT return the front casters to the ground until the wheelchair has been pulled backward far enough for the front casters to clear the edge of the curb.

Solara™

16

Part No. 1080556 Rev. I

Image 16
Contents Solara SolaraLimited Solara Table of Contents Procedure 7 TILT-IN-SPACE Special Notes Special NotesLabel Locations Label LocationsHeavy Duty Package only Transport Ready Option only Specifications SpecificationsInformation for Healthcare PROFESSIONALS/ Assistants General GuidelinesAnterior Forward Tilt General GuidelinesProcedure General Guidelines Stability ALL ModelsStability ALL Models Except Recliners Stability WarningOperating Information Stability Recliner Models onlyGeneral Warnings Weight Training Weight LimitationStability and Balance SAFETY/HANDLING of WheelchairsCoping with Everyday Obstacles Center Gravity Percentage of Weight DistributionUnoccupied Occupied General Guidelines Procedure General Guidelines Tipping Tipping Curbs Method 1 Wheelchair with Step TubesMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeWithout Step Tube Method 2 WheelchairStairways ESCALATORS? Sorry Transferring to and from Other SeatsSafety Inspection Safety Inspection ChecklistSafety Inspection Troubleshooting MaintenanceProcedure 2SAFETY Inspection Maintenance Safety PrecautionsTransporting Transporting the Invacare SolaraTransporting INSTALLING/REMOVING Swingaway Footrest Figure Procedure Front RiggingsInstalling Front RiggingsHeight Adjustment Ranges Adjusting Swingaway Footrest HeightMFX and 90 Footrests Figure Installing Adjustable Angle FLIP-UP Footplate Hinge Figure Installing Adjustable Angle FLIP-UP Footplate HingeReplacement Figure COMPOSITE/ARTICULATING Footplate Heel LoopAdjusting the Legrest Adjusting the Elevating LEGREST/CALFPAD Assembly FigureAdjusting the Calfpad Arms Procedure Installing ArmrestRemoving Armrest ArmsProcedure Arms Adjusting Armrest INSTALLING/REMOVING/ADJUSTING Dual Point ArmrestUSING/INSTALLING/ADJUSTING Locking Cantilever Arms Using Locking Cantilever Arms FigureAdjusting Locking Cantilever ARM Height Figure RearAdjusting Locking Cantilever ARM Angle Figure Procedure Arms110 120 Using NON-LOCKING Cantilever Arms Figure USING/INSTALLING/ADJUSTING NON-LOCKING Cantilever ArmsAdjusting NON-LOCKING Cantilever ARM Height Figure Detail a Side View of CAM ARM AngleARM PAD Replacement for Cantilever Arms Figure INSTALLING/REMOVING T-ARMS FigureInstalling T-ARMS Removing T-ARMSAdjusting the T-ARMS Adjusting T-ARM Height FigureProcedure Arms Adjusting T-ARM Depth Figure Adjusting T-ARM Sockets FigureAdjusting T-ARM Transfer Assists AND/OR Side Guards Figure Adjusting T-ARM Transfer Assists AND/OR Side GuardsProcedure BACK/SEAT FOLDING/UNFOLDING Back Assembly FigureBACK/SEAT Installing INSTALLING/REMOVING the Stroller Handles FigureRemoving Detail a QUICK-RELEASE PIN Installed Installing FigureRemoving Figure Adjusting Figure Locked PositionINSTALLING/REPLACING Seat Positioning Straps Figure ReplacingINSTALLING/REPLACING the Back Upholstery Figure BACK/SEATPROCEDURERear Installing the Seat Cushion FigureWheelchair Front TILT-IN-SPACE Engaging TILT-IN-SPACE FigureTILT-IN-SPACE Adjusting Trigger Release Cables Figure Procedure TILT-IN-SPACEPositioning Tilt Locking Collars Adjusting Upper Tilt Locking Collar FigureTilt Locking Collar Adjusting Lower Tilt Locking Collar INSTALLING/REMOVING Rear Wheels WHEELS/FORKSQUICK-RELEASE Figure WHEELS/FORKSAdjusting the QUICK-RELEASE Axle Figure Procedure WHEELS/FORKS Permanent Axle FigurePermanent Axle QUICK-RELEASE AxleSEAT-TO-FLOOR Height Adjustment Adjusting Forks FigureWheel Lock Adjustment Figure Procedure Wheel LOCKS/ANTI-TIPPERSWheel LOCKS/ ANTI-TIPPERS Foot Activated Wheel Lock Inch Wheels onlyUsing the Wheel Locks INSTALLING/ADJUSTING ANTI-TIPPERS FigureFoot Activated Wheel Locks 12-INCH Wheels only Figure LOCKS/ -TIPPERSINSTALLING/ADJUSTING ANTI-TIPPERS ANTI-TIPPER Facing DownRecliner Back Option Recliner Operation FigureRecliner Back Option Procedure Recliner Back Option Recliner OperationAdjusting the Recliner Cables Replacing BACK/HEADREST Upholstery FigureBack Upholstery Headrest UpholsteryReplacing the Recliner Cables Figure Installing NEW Recliner CablesRemoving Existing Recliner Cables Detail B Detail aOption Replacing the GAS Cylinders Figure Actuator Centered TOO LOW TOO HighReplacing the GAS Cylinders Determining Necessary Adjustments Adjusting the GAS Cylinders FigurePerforming Adjustments Detail B Must TOO TOO Look LOW High Like this Installing the Contracture Footplate Assembly Procedure Contracture Footplate OptionInstalling the Crossmember Assembly Figure Contracture Footplate OptionDetail B Lock Contracture Assembly Angle Adjustment Figure Using the Optional QUICK-RELEASE PIN FigureAngle Adjustment of the Contracture Contracture Footplate Height Adjustment Figure Bilateral ContractureReplacing the Contracture Footplate Heel Loop Figure Replacing the Contracture Footplate Heel LoopTransport Ready Option Transport Ready OptionCompliance Information Securing the Wheelchair to the VehicleSecurement Points Figure Front Rear Securing the OccupantWHEELCHAIR-ANCHORED Belts Figure Procedure Transport Ready Option Detail a Pelvic Belt WHEELCHAIR-ANCHORED BeltsTransport Ready Positioning Belts FigurePositioning Belts Part No Rev Solara Warranty WarrantyOne Invacare Way