PROCEDURE 5 | ARMS |
Back Cane
ARMS
Adjustment Plate
Coved Washers
Actuator
Spacer
Top Hex Bolt
and Coved Washer
Cantilever Arm
Bottom Hex Bolt
Locknuts
Washers
FIGURE 3 - INSTALLING LOCKING CANTILEVER ARMS /
ADJUSTING LOCKING CANTILEVER ARM HEIGHT
ADJUSTING LOCKING CANTILEVER ARM ANGLE (FIGURE 4)
NOTE: This adjustment is recommended if the back angle has been changed.
1.Flip the cantilever arm up and out of the way.
2.Remove the locknut that secures the locking pin to the arm adjustment plate.
3.Refer to FIGURE 4 to determine the mounting hole in the arm adjustment plate that will be used to correspond to the back angle.
4.Securely tighten the locking pin and washer to the adjustment plate with a locknut.
5.Repeat STEPS
Solara™ | 30 | Part No. 1080556 Rev. I |