RECLINER BACK OPTION | PROCEDURE 10 | |
|
|
|
WARNING
DO NOT over tighten the adjusting nut on the recliner cable. Overtightening the adjusting nut on the recliner cable WILL actuate the gas cylinder, possibly causing injury.
A.CLOCKWISE - Turning the cable adjusting nut clockwise will tighten the recliner cable. DO NOT overtighten the cable adjusting nut. Turn the cable adjusting nut clockwise until actuator looks like DETAIL "B".
B.COUNTERCLOCKWISE - Turning the cable adjusting nut counterclockwise will loosen the recliner cable.
NOTE: If the recliner cable is too loose, the gas cylinders will not work.
C.While holding the cable adjusting nut in place, tighten the cable locking nut against the cable adjusting nut.
D.Repeat STEP 1.
E.Repeat STEP 2 until the LEFT side of the back DOES NOT recline.
3.Squeeze the trigger release lever of the RIGHT recliner cable assembly and try to recline the back. The back should not recline.
4.To adjust the RIGHT gas cylinder:
Repeat STEPS
RECLINER BACK OPTION
Trigger
Release
Lever
Cable Locking
Nut
Cable Adjusting
Nut
DETAIL "B"
MUST TOO TOO
LOOK LOW HIGH LIKE THIS
Actuator Actuator
Housing
FIGURE 5 - PERFORMING ADJUSTMENTS
Part No. 1080556 Rev. I | 63 | Solara™ |