Invacare 1080556 manual INSTALLING/REMOVING Rear Wheels, Wheels/Forks, QUICK-RELEASE Figure

Page 49

WHEELS/FORKS

PROCEDURE 8

This Procedure Includes the Following:

Installing/Removing Rear Wheels

Adjusting the Quick-Release Axle

Seat-to-Floor Height Adjustment

Adjusting Forks

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attach- ing hardware is tightened securely - otherwise injury or damage may result.

INSTALLING/REMOVING REAR WHEELS

QUICK-RELEASE (FIGURE 1)

NOTE: To remove rear wheels, reverse this procedure.

1.Push in the detent pin of the quick-release axle and insert the quick-release axle through the center of the rear wheel.

2.Push in the tip of the quick-release axle again and insert the axle (with wheel) into the axle mounting plate on the side of the wheelchair frame until the assembly locks in place.

WARNING

Make sure detent pin and locking pins of the quick-release axles are fully released BEFORE operating the wheelchair.

The locking pins MUST be protruding past the inside of the axle mounting plate for a positive lock.

Keep locking pins clean.

3.

If the locking pins of the quick-release

Wheelchair

 

axles are not protruding past the inside of

 

the axle mounting plate or there is too

Frame

 

much movement of the rear wheel

Axle Mounting

 

assembly in a back and forth position,

 

refer to ADJUSTING THE QUICK-

Plate

 

RELEASE AXLE in this procedure of the

Locking

 

manual.

 

Pins

4. Repeat STEPS 1-3 for other rear wheel

Detent

 

assembly.

 

Pin

5.

Adjust the wheel locks. Refer to WHEEL

 

 

LOCK ADJUSTMENT in PROCEDURE 9 of

 

 

this manual.

 

NOTE: Only 12-inch rear wheel is shown. All other

Quick-Release

Axle

wheels will install/remove in the same manner.

Rear Wheel

FIGURE 1 - INSTALLING/

REMOVING REAR WHEELS -

QUICK-RELEASE

WHEELS/FORKS

Part No. 1080556 Rev. I

49

Solara™

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Solara SolaraLimited Solara Table of Contents Procedure 7 TILT-IN-SPACE Special Notes Special NotesLabel Locations Label LocationsHeavy Duty Package only Transport Ready Option only Specifications SpecificationsGeneral Guidelines Information for Healthcare PROFESSIONALS/ AssistantsAnterior Forward Tilt General GuidelinesStability ALL Models Procedure General GuidelinesStability ALL Models Except Recliners Stability WarningOperating Information Stability Recliner Models onlyGeneral Warnings Weight Limitation Weight TrainingStability and Balance SAFETY/HANDLING of WheelchairsCoping with Everyday Obstacles Center Gravity Percentage of Weight DistributionUnoccupied Occupied General Guidelines Tipping Curbs Method 1 Wheelchair with Step Tubes Procedure General Guidelines TippingMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeWithout Step Tube Method 2 WheelchairStairways Transferring to and from Other Seats ESCALATORS? SorrySafety Inspection Safety Inspection ChecklistSafety Inspection Maintenance TroubleshootingProcedure 2SAFETY Inspection Maintenance Safety PrecautionsTransporting Transporting the Invacare SolaraTransporting Procedure Front Riggings INSTALLING/REMOVING Swingaway Footrest FigureInstalling Front RiggingsHeight Adjustment Ranges Adjusting Swingaway Footrest HeightMFX and 90 Footrests Figure Installing Adjustable Angle FLIP-UP Footplate Hinge Installing Adjustable Angle FLIP-UP Footplate Hinge FigureCOMPOSITE/ARTICULATING Footplate Heel Loop Replacement FigureAdjusting the Legrest Adjusting the Elevating LEGREST/CALFPAD Assembly FigureAdjusting the Calfpad Installing Armrest Arms ProcedureRemoving Armrest ArmsINSTALLING/REMOVING/ADJUSTING Dual Point Armrest Procedure Arms Adjusting ArmrestUsing Locking Cantilever Arms Figure USING/INSTALLING/ADJUSTING Locking Cantilever ArmsAdjusting Locking Cantilever ARM Height Figure RearProcedure Arms Adjusting Locking Cantilever ARM Angle Figure110 120 Using NON-LOCKING Cantilever Arms Figure USING/INSTALLING/ADJUSTING NON-LOCKING Cantilever ArmsAdjusting NON-LOCKING Cantilever ARM Height Figure ARM Angle Detail a Side View of CAMINSTALLING/REMOVING T-ARMS Figure ARM PAD Replacement for Cantilever Arms FigureInstalling T-ARMS Removing T-ARMSAdjusting T-ARM Height Figure Adjusting the T-ARMSAdjusting T-ARM Sockets Figure Procedure Arms Adjusting T-ARM Depth FigureAdjusting T-ARM Transfer Assists AND/OR Side Guards Adjusting T-ARM Transfer Assists AND/OR Side Guards FigureProcedure BACK/SEAT FOLDING/UNFOLDING Back Assembly FigureBACK/SEAT Installing INSTALLING/REMOVING the Stroller Handles FigureRemoving Detail a QUICK-RELEASE PIN Installed Installing FigureRemoving Figure Locked Position Adjusting FigureReplacing INSTALLING/REPLACING Seat Positioning Straps FigureBACK/SEATPROCEDURE INSTALLING/REPLACING the Back Upholstery FigureRear Installing the Seat Cushion FigureWheelchair Front TILT-IN-SPACE Engaging TILT-IN-SPACE FigureTILT-IN-SPACE Procedure TILT-IN-SPACE Adjusting Trigger Release Cables FigurePositioning Tilt Locking Collars Adjusting Upper Tilt Locking Collar FigureTilt Locking Collar Adjusting Lower Tilt Locking Collar WHEELS/FORKS INSTALLING/REMOVING Rear WheelsQUICK-RELEASE Figure WHEELS/FORKSProcedure WHEELS/FORKS Permanent Axle Figure Adjusting the QUICK-RELEASE Axle FigurePermanent Axle QUICK-RELEASE AxleAdjusting Forks Figure SEAT-TO-FLOOR Height AdjustmentProcedure Wheel LOCKS/ANTI-TIPPERS Wheel Lock Adjustment FigureWheel LOCKS/ ANTI-TIPPERS Foot Activated Wheel Lock Inch Wheels onlyINSTALLING/ADJUSTING ANTI-TIPPERS Figure Using the Wheel LocksFoot Activated Wheel Locks 12-INCH Wheels only Figure LOCKS/ -TIPPERSANTI-TIPPER Facing Down INSTALLING/ADJUSTING ANTI-TIPPERSRecliner Back Option Recliner Operation FigureRecliner Back Option Recliner Operation Procedure Recliner Back OptionReplacing BACK/HEADREST Upholstery Figure Adjusting the Recliner CablesBack Upholstery Headrest UpholsteryReplacing the Recliner Cables Figure Installing NEW Recliner CablesRemoving Existing Recliner Cables Detail B Detail aOption Actuator Centered TOO LOW TOO High Replacing the GAS Cylinders FigureReplacing the GAS Cylinders Determining Necessary Adjustments Adjusting the GAS Cylinders FigurePerforming Adjustments Detail B Must TOO TOO Look LOW High Like this Procedure Contracture Footplate Option Installing the Contracture Footplate AssemblyInstalling the Crossmember Assembly Figure Contracture Footplate OptionDetail B Lock Using the Optional QUICK-RELEASE PIN Figure Contracture Assembly Angle Adjustment FigureAngle Adjustment of the Contracture Bilateral Contracture Contracture Footplate Height Adjustment FigureReplacing the Contracture Footplate Heel Loop Replacing the Contracture Footplate Heel Loop FigureTransport Ready Option Transport Ready OptionSecuring the Wheelchair to the Vehicle Compliance InformationSecurement Points Figure Front Rear Securing the OccupantWHEELCHAIR-ANCHORED Belts Figure WHEELCHAIR-ANCHORED Belts Procedure Transport Ready Option Detail a Pelvic BeltPositioning Belts Figure Transport ReadyPositioning Belts Part No Rev Solara Warranty WarrantyOne Invacare Way
Top Page Image Contents