Invacare 1080556 manual INSTALLING/REMOVING Swingaway Footrest Figure, Front Riggings, Installing

FRONT RIGGINGS

PROCEDURE 4 FRONT RIGGINGS

This Procedure Includes the Following:

Installing/Removing Swingaway Footrest

Adjusting Swingaway Footrest Height

Adjusting Adjustable Angle Flip-up Footplates

Composite/Articulating Footplate Heel Loop Replacement

Installing/Removing Elevating Legrest/Calfpad Assembly

Adjusting the Elevating Legrest/Calfpad Assembly

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.

INSTALLING/REMOVING SWINGAWAY FOOTREST (FIGURE 1)

INSTALLING

1.Turn the footrest to the side (open footplate is perpendicular to the wheelchair).

2.Insert the footrest assembly mounting pin into the mounting tube of the wheelchair frame.

3.Rotate the footrest towards the inside of the wheelchair until it locks into place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1-3 for the other footrest assembly.

5.If necessary, adjust the footrest height. Refer to ADJUSTING SWINGAWAY FOOTREST HEIGHT in this procedure of the manual.

REMOVING

1.Push the footrest release lever inward while rotating the footrest outward.

2.Lift the footrest assembly out of the mounting pin of the wheelchair frame.

3.Repeat STEPS 1-2 for opposite side, if necessary.

Footrest Release	Mounting Pin
Lever
Mounting	Footrest
Tube	Assembly
Wheelchair	Footplate
Frame

NOTE: Only 60° Front Rigging shown for clarity. Others will attach the same way.

FIGURE 1 - INSTALLING/REMOVING SWINGAWAY FOOTREST

Solara™ 22 Part No. 1080556 Rev. I