Invacare 1080556 manual Installing Adjustable Angle FLIP-UP Footplate Hinge Figure

FRONT RIGGINGS

PROCEDURE 4 FRONT RIGGINGS

INSTALLING ADJUSTABLE ANGLE FLIP-UP FOOTPLATE HINGE (FIGURE 4)

1.Position the adjustable angle flip-up footplate hinge on the footrest support tube at the desired height.

2.Position the hardware on the footrest support as shown in FIGURE 4.

3.Flip the footplate hinge to the UP position.

NOTE: The footplate hinge will fall to the DOWN position.

4.Tighten the socket screw and locknut that secure the footplate hinge to the footrest support until the footplate hinge remains in the UP position.

5.Check the up and down motion of the footplate hinge to make sure the user of the wheelchair can operate the footplates easily.

NOTE: If the footplate's motion is too tight, loosen the socket screw and locknut approximately 1/4-turn.

NOTE: If the footplate's motion is too loose, tighten the socket screw and locknut approximately 1/4-turn.

Locknut

Footplate

Footrest

Support

Tube

HingeSocket

Screw

FIGURE 4 - INSTALLING ADJUSTABLE ANGLE

FLIP-UP FOOTPLATE HINGE

Solara™ 24 Part No. 1080556 Rev. I