WHEELS/FORKS | PROCEDURE 8 | |
|
|
|
SEAT-TO-FLOOR HEIGHT ADJUSTMENT
WARNING
Repositioning the axle plates
ADJUSTING FORKS (FIGURE 4)
1.Remove the dust cover from the caster headtube.
2.To properly tighten caster journal system and guard against flutter, perform the following check:
A.Tip back the wheelchair to floor.
B.Pivot both forks and casters to top of their arc simultaneously.
C.Let casters drop to bottom of arc (wheels should swing once to
D.Adjust locknuts according to freedom of caster swing.
3.Test wheelchair for maneuverability.
4.Readjust locknuts if necessary, and repeat STEPS
5.Snap dust cover into the caster headtube.
6.Repeat STEPS
Dust Cover
Locknut
Caster
Headtube
WHEELS/FORKS
FIGURE 4 - ADJUSTING FORKS
Part No. 1080556 Rev. I | 51 | Solara™ |