Invacare 1080556 manual ARM PAD Replacement for Cantilever Arms Figure, Installing T-ARMS

ARMS

PROCEDURE 5 ARMS

ARM PAD REPLACEMENT FOR CANTILEVER ARMS (FIGURE 8)

1.Remove the mounting screws from the armrest pad.

2.Replace with NEW armrest pad.

3.Secure with existing hardware.

DESK LENGTH ARM PADS	FULL LENGTH ARM PADS
Armrest Pad		Arm Pad
Cantilever		Cantilever
	Cantilever	Slide Tube
Arm Tube	Arm Tube
Mounting Screws	Mounting Screws
FIGURE 8 - ARM PAD REPLACEMENT FOR CANTILEVER ARMS

INSTALLING/REMOVING T-ARMS (FIGURE 9)

INSTALLING T-ARMS

1.Position the T-arm over the T-arm socket on the wheelchair frame.

NOTE: Make sure the locking lever is towards the front of the wheelchair.

2.Slide T-arm into T-arm socket until the locking lever is in the slot in the T-arm socket and an audible "click" is heard.

3.Pull up on T-arm to make sure T-arm is locked in place.

NOTE: If the T-arm does not slide in the T-arm socket as desired, adjust the T-arm socket. Refer to ADJUST- ING THE T-ARMS in this procedure of the manual.

4.Adjust the T-arm for desired height, width and depth, if necessary. Refer to ADJUSTING THE T-ARMS in this procedure of the manual.

5.Repeat STEPS 1-4 for opposite side of wheelchair.

REMOVING T-ARMS

T-Arm

Wheelchair
Frame	Locking Lever
	(towards the front
T-Arm	of the wheelchair)
Socket
	Slot

FIGURE 9 - INSTALLING/

REMOVING T- ARMS

1. Press in on the locking lever and lift the T-arm straight up and out of the T-arm socket.

NOTE: If the T-arm does not slide up and down in the T-arm socket as desired, adjust the T-arm socket. Refer to ADJUSTING THE T-ARMS in this procedure of the manual.

2. Repeat STEP 2 for opposite side of the wheelchair.

Solara™ 34 Part No. 1080556 Rev. I