Invacare 1080556 manual Method 2 Wheelchair, Without Step Tube, Stairways

Page 17

GENERAL GUIDELINES

PROCEDURE 1

 

 

WARNING

 

When lowering the front casters of

 

the wheelchair, DO NOT let the

 

wheelchair drop the last few inches to

 

the ground. This could result in injury

 

to the occupant and/or damage to the

 

wheelchair.

 

 

 

 

 

Roll the wheelchair backward and SLOWLY

 

lower the wheelchair in one continuous

 

movement. DO NOT let the wheelchair drop

METHOD 2 - WHEELCHAIR

the last few inches to the ground. This could

WITHOUT STEP TUBE

result in injury to the occupant.

 

STAIRWAYS

 

WARNING

ALWAYS wear your seat/chest positioning strap. Inasmuch as the SEAT/ CHEST POSITIONING STRAP is an option on this wheelchair (You may order with or without the Seat/Chest Positioning Strap), Invacare strongly recom- mends ordering the Seat/Chest Positioning Strap as an additional safeguard for the wheelchair user.

Do not attempt to lift a wheelchair by lifting on any removable (detachable) parts. Lifting by means of any removable (detachable) parts of a wheelchair may result in injury to the user or damage to the wheelchair.

Extreme caution is advised when it is necessary to move an occupied wheel- chair up or down the stairs. Invacare recommends that, if possible, the user be removed from the wheelchair prior to moving. Invacare recommends using two (2) assistants and making thorough preparations. Make sure to use ONLY secure, non-detachable parts for hand-held supports.

Follow this procedure for moving the wheelchair between floors when an elevator is NOT available:

1.If necessary, rotate the anti-tippers so the wheels are facing up.

2.After the wheelchair has been tilted back to the balance point, one assistant (in the rear) backs the wheelchair up against the first step, while securely grasping a non-removable (non-detachable) part of the wheelchair for leverage.

3.The second assistant, with a firm hold on a non-detachable part of the framework, lifts the wheelchair up and over the stair and steadies the wheelchair as the first assistant places one (1) foot on the next stair and repeats STEP 1.

4.The wheelchair should not be lowered until the last stair has been negotiated and the wheelchair has been rolled away from the stairway.

5.If necessary, rotate the anti-tippers so the wheels are facing down.

GENERAL GUIDELINES

Part No. 1080556 Rev. I

17

Solara™

Image 17
Contents Solara SolaraLimited Solara Table of Contents Procedure 7 TILT-IN-SPACE Special Notes Special NotesHeavy Duty Package only Label LocationsLabel Locations Transport Ready Option only Specifications SpecificationsGeneral Guidelines Information for Healthcare PROFESSIONALS/ AssistantsAnterior Forward Tilt General GuidelinesStability ALL Models Procedure General GuidelinesStability ALL Models Except Recliners Stability WarningGeneral Warnings Stability Recliner Models onlyOperating Information Weight Limitation Weight TrainingCoping with Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance Unoccupied Occupied Percentage of Weight DistributionCenter Gravity General Guidelines Tipping Curbs Method 1 Wheelchair with Step Tubes Procedure General Guidelines TippingMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeStairways Method 2 WheelchairWithout Step Tube Transferring to and from Other Seats ESCALATORS? SorrySafety Inspection Safety Inspection ChecklistSafety Inspection Maintenance TroubleshootingProcedure 2SAFETY Inspection Maintenance Safety PrecautionsTransporting Transporting the Invacare SolaraTransporting Procedure Front Riggings INSTALLING/REMOVING Swingaway Footrest FigureInstalling Front RiggingsMFX and 90 Footrests Figure Adjusting Swingaway Footrest HeightHeight Adjustment Ranges Installing Adjustable Angle FLIP-UP Footplate Hinge Installing Adjustable Angle FLIP-UP Footplate Hinge FigureCOMPOSITE/ARTICULATING Footplate Heel Loop Replacement FigureAdjusting the Calfpad Adjusting the Elevating LEGREST/CALFPAD Assembly FigureAdjusting the Legrest Installing Armrest Arms ProcedureRemoving Armrest ArmsINSTALLING/REMOVING/ADJUSTING Dual Point Armrest Procedure Arms Adjusting ArmrestUsing Locking Cantilever Arms Figure USING/INSTALLING/ADJUSTING Locking Cantilever ArmsAdjusting Locking Cantilever ARM Height Figure RearProcedure Arms Adjusting Locking Cantilever ARM Angle Figure110 120 Adjusting NON-LOCKING Cantilever ARM Height Figure USING/INSTALLING/ADJUSTING NON-LOCKING Cantilever ArmsUsing NON-LOCKING Cantilever Arms Figure ARM Angle Detail a Side View of CAMINSTALLING/REMOVING T-ARMS Figure ARM PAD Replacement for Cantilever Arms FigureInstalling T-ARMS Removing T-ARMSAdjusting T-ARM Height Figure Adjusting the T-ARMSAdjusting T-ARM Sockets Figure Procedure Arms Adjusting T-ARM Depth FigureAdjusting T-ARM Transfer Assists AND/OR Side Guards Adjusting T-ARM Transfer Assists AND/OR Side Guards FigureBACK/SEAT FOLDING/UNFOLDING Back Assembly FigureProcedure BACK/SEAT Removing INSTALLING/REMOVING the Stroller Handles FigureInstalling Removing Figure Installing FigureDetail a QUICK-RELEASE PIN Installed Locked Position Adjusting FigureReplacing INSTALLING/REPLACING Seat Positioning Straps FigureBACK/SEATPROCEDURE INSTALLING/REPLACING the Back Upholstery FigureWheelchair Front Installing the Seat Cushion FigureRear TILT-IN-SPACE Engaging TILT-IN-SPACE FigureTILT-IN-SPACE Procedure TILT-IN-SPACE Adjusting Trigger Release Cables FigureTilt Locking Collar Adjusting Upper Tilt Locking Collar FigurePositioning Tilt Locking Collars Adjusting Lower Tilt Locking Collar WHEELS/FORKS INSTALLING/REMOVING Rear WheelsQUICK-RELEASE Figure WHEELS/FORKSProcedure WHEELS/FORKS Permanent Axle Figure Adjusting the QUICK-RELEASE Axle FigurePermanent Axle QUICK-RELEASE AxleAdjusting Forks Figure SEAT-TO-FLOOR Height AdjustmentProcedure Wheel LOCKS/ANTI-TIPPERS Wheel Lock Adjustment FigureWheel LOCKS/ ANTI-TIPPERS Foot Activated Wheel Lock Inch Wheels onlyINSTALLING/ADJUSTING ANTI-TIPPERS Figure Using the Wheel LocksFoot Activated Wheel Locks 12-INCH Wheels only Figure LOCKS/ -TIPPERSANTI-TIPPER Facing Down INSTALLING/ADJUSTING ANTI-TIPPERSRecliner Back Option Recliner Operation FigureRecliner Back Option Recliner Operation Procedure Recliner Back OptionReplacing BACK/HEADREST Upholstery Figure Adjusting the Recliner CablesBack Upholstery Headrest UpholsteryRemoving Existing Recliner Cables Installing NEW Recliner CablesReplacing the Recliner Cables Figure Option Detail aDetail B Actuator Centered TOO LOW TOO High Replacing the GAS Cylinders FigureReplacing the GAS Cylinders Performing Adjustments Adjusting the GAS Cylinders FigureDetermining Necessary Adjustments Detail B Must TOO TOO Look LOW High Like this Procedure Contracture Footplate Option Installing the Contracture Footplate AssemblyInstalling the Crossmember Assembly Figure Contracture Footplate OptionDetail B Lock Using the Optional QUICK-RELEASE PIN Figure Contracture Assembly Angle Adjustment FigureAngle Adjustment of the Contracture Bilateral Contracture Contracture Footplate Height Adjustment FigureReplacing the Contracture Footplate Heel Loop Replacing the Contracture Footplate Heel Loop FigureTransport Ready Option Transport Ready OptionSecuring the Wheelchair to the Vehicle Compliance InformationWHEELCHAIR-ANCHORED Belts Figure Securing the OccupantSecurement Points Figure Front Rear WHEELCHAIR-ANCHORED Belts Procedure Transport Ready Option Detail a Pelvic BeltPositioning Belts Figure Transport ReadyPositioning Belts Part No Rev Solara Warranty WarrantyOne Invacare Way