Invacare 1080556 manual COMPOSITE/ARTICULATING Footplate Heel Loop, Replacement Figure

Page 25

FRONT RIGGINGS		PROCEDURE 4
	COMPOSITE/ARTICULATING FOOTPLATE HEEL LOOP
	REPLACEMENT (FIGURE 5)	COMPOSITE FOOTPLATE

DISASSEMBLY

Composite.

1.Remove the hex screw and coved spacer that secure the lower footrest assembly to the swing away footrest assembly.

2.Remove the lower footrest assembly.

3.Remove the phillips screw and locknut that secure the heel loop to the footrest.

4.Slide heel loop off of the footrest.

Articulating.

1.Remove the phillips screws, washers and spacers that secure the heel loop to the articulating footplate.

REASSEMBLY

1. Replace heel loop.

Swingaway Footrest Assembly

Hex Screw and Coved Spacer

	Phillips Screw
		Lower Footrest	Phillips
		Lower Footrest	Screws
	Spacer	Assembly	Screws
		Assembly

	Heel		Washer
	Heel
	Loop		Heel
			Heel
	Locknut	Spacer	Loop
		Spacer

ARTICULATING

FOOTPLATE

FRONT RIGGINGS

2. Reverse the disassembly procedures.	FIGURE 5 - COMPOSITE/
NOTE: When securing the heel loop to the footrest as-	ARTICULATING FOOTPLATE
sembly, tighten phillips screw until the spacer is secure.	HEEL LOOP REPLACEMENT

INSTALLING/REMOVING ELEVATING LEGREST/CALFPAD ASSEMBLY (FIGURE 6)

INSTALLING

1.Insert the footplate assembly into the calfpad assembly and secure it with bolt and nut.

2.Place legrest/calfpad assembly on the outside of the wheelchair and insert legrest mounting pin into the legrest mounting tube on the wheelchair frame.

3.Rotate legrest/calfpad assembly toward the inside of the wheelchair until it locks in place.

NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place.

4.Repeat STEPS 1-3 for the other legrest assembly.

Legrest	Legrest Mounting Pin
Mounting
Tube	Calfpad
	Calfpad
	Assembly

Bolt and

ReleaseNut

Wheelchair Handle

Frame

Footplate Assembly

FIGURE 6 - INSTALLING/

REMOVING ELEVATING LEGREST/

CALFPAD ASSEMBLY

5.Adjust the footplate to the correct height by loosening the bolt and nut and sliding the inner tube up or down until desired height is achieved. Securely tighten bolt and nut.

REMOVING

1.Push the legrest release handle inward while rotating the footrest outward.

2.Lift the legrest assembly out of the legrest mounting tube.

Part No. 1080556 Rev. I

25

Solara™

Image 25

Contents Solara SolaraLimited Solara Table of Contents Procedure 7 TILT-IN-SPACE Special Notes Special NotesLabel Locations Label LocationsHeavy Duty Package only Transport Ready Option only Specifications SpecificationsGeneral Guidelines Information for Healthcare PROFESSIONALS/ AssistantsAnterior Forward Tilt General GuidelinesStability ALL Models Procedure General GuidelinesStability ALL Models Except Recliners Stability WarningOperating Information Stability Recliner Models onlyGeneral Warnings Weight Limitation Weight TrainingStability and Balance SAFETY/HANDLING of WheelchairsCoping with Everyday Obstacles Center Gravity Percentage of Weight DistributionUnoccupied Occupied General Guidelines Tipping Curbs Method 1 Wheelchair with Step Tubes Procedure General Guidelines TippingMethod 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeWithout Step Tube Method 2 WheelchairStairways Transferring to and from Other Seats ESCALATORS? SorrySafety Inspection Safety Inspection ChecklistSafety Inspection Maintenance TroubleshootingProcedure 2SAFETY Inspection Maintenance Safety PrecautionsTransporting Transporting the Invacare SolaraTransporting Procedure Front Riggings INSTALLING/REMOVING Swingaway Footrest FigureInstalling Front RiggingsHeight Adjustment Ranges Adjusting Swingaway Footrest HeightMFX and 90 Footrests Figure Installing Adjustable Angle FLIP-UP Footplate Hinge Installing Adjustable Angle FLIP-UP Footplate Hinge FigureCOMPOSITE/ARTICULATING Footplate Heel Loop Replacement FigureAdjusting the Legrest Adjusting the Elevating LEGREST/CALFPAD Assembly FigureAdjusting the Calfpad Installing Armrest Arms ProcedureRemoving Armrest ArmsINSTALLING/REMOVING/ADJUSTING Dual Point Armrest Procedure Arms Adjusting ArmrestUsing Locking Cantilever Arms Figure USING/INSTALLING/ADJUSTING Locking Cantilever ArmsAdjusting Locking Cantilever ARM Height Figure RearProcedure Arms Adjusting Locking Cantilever ARM Angle Figure110 120 Using NON-LOCKING Cantilever Arms Figure USING/INSTALLING/ADJUSTING NON-LOCKING Cantilever ArmsAdjusting NON-LOCKING Cantilever ARM Height Figure ARM Angle Detail a Side View of CAMINSTALLING/REMOVING T-ARMS Figure ARM PAD Replacement for Cantilever Arms FigureInstalling T-ARMS Removing T-ARMSAdjusting T-ARM Height Figure Adjusting the T-ARMSAdjusting T-ARM Sockets Figure Procedure Arms Adjusting T-ARM Depth FigureAdjusting T-ARM Transfer Assists AND/OR Side Guards Adjusting T-ARM Transfer Assists AND/OR Side Guards FigureProcedure BACK/SEAT FOLDING/UNFOLDING Back Assembly FigureBACK/SEAT Installing INSTALLING/REMOVING the Stroller Handles FigureRemoving Detail a QUICK-RELEASE PIN Installed Installing FigureRemoving Figure Locked Position Adjusting FigureReplacing INSTALLING/REPLACING Seat Positioning Straps FigureBACK/SEATPROCEDURE INSTALLING/REPLACING the Back Upholstery FigureRear Installing the Seat Cushion FigureWheelchair Front TILT-IN-SPACE Engaging TILT-IN-SPACE FigureTILT-IN-SPACE Procedure TILT-IN-SPACE Adjusting Trigger Release Cables FigurePositioning Tilt Locking Collars Adjusting Upper Tilt Locking Collar FigureTilt Locking Collar Adjusting Lower Tilt Locking Collar WHEELS/FORKS INSTALLING/REMOVING Rear WheelsQUICK-RELEASE Figure WHEELS/FORKSProcedure WHEELS/FORKS Permanent Axle Figure Adjusting the QUICK-RELEASE Axle FigurePermanent Axle QUICK-RELEASE AxleAdjusting Forks Figure SEAT-TO-FLOOR Height AdjustmentProcedure Wheel LOCKS/ANTI-TIPPERS Wheel Lock Adjustment FigureWheel LOCKS/ ANTI-TIPPERS Foot Activated Wheel Lock Inch Wheels onlyINSTALLING/ADJUSTING ANTI-TIPPERS Figure Using the Wheel LocksFoot Activated Wheel Locks 12-INCH Wheels only Figure LOCKS/ -TIPPERSANTI-TIPPER Facing Down INSTALLING/ADJUSTING ANTI-TIPPERSRecliner Back Option Recliner Operation FigureRecliner Back Option Recliner Operation Procedure Recliner Back OptionReplacing BACK/HEADREST Upholstery Figure Adjusting the Recliner CablesBack Upholstery Headrest UpholsteryReplacing the Recliner Cables Figure Installing NEW Recliner CablesRemoving Existing Recliner Cables Detail B Detail aOption Actuator Centered TOO LOW TOO High Replacing the GAS Cylinders FigureReplacing the GAS Cylinders Determining Necessary Adjustments Adjusting the GAS Cylinders FigurePerforming Adjustments Detail B Must TOO TOO Look LOW High Like this Procedure Contracture Footplate Option Installing the Contracture Footplate AssemblyInstalling the Crossmember Assembly Figure Contracture Footplate OptionDetail B Lock Using the Optional QUICK-RELEASE PIN Figure Contracture Assembly Angle Adjustment FigureAngle Adjustment of the Contracture Bilateral Contracture Contracture Footplate Height Adjustment FigureReplacing the Contracture Footplate Heel Loop Replacing the Contracture Footplate Heel Loop FigureTransport Ready Option Transport Ready OptionSecuring the Wheelchair to the Vehicle Compliance InformationSecurement Points Figure Front Rear Securing the OccupantWHEELCHAIR-ANCHORED Belts Figure WHEELCHAIR-ANCHORED Belts Procedure Transport Ready Option Detail a Pelvic BeltPositioning Belts Figure Transport ReadyPositioning Belts Part No Rev Solara Warranty WarrantyOne Invacare Way