Invacare 1080556 manual Adjusting the QUICK-RELEASE Axle Figure, Permanent Axle

Page 50

WHEELS/FORKS

PROCEDURE 8

WHEELS/FORKS

PERMANENT AXLE (FIGURE 2)

NOTE: To remove rear wheels, reverse this procedure.

1.

Remove the permanent axles from the

 

 

 

packaged container.

 

 

2.

Install permanent axle through the rear

 

 

 

wheel and axle plate.

 

 

3.

Securely tighten the wheel to the

 

 

 

wheelchair frame with locknut.

Axle Plate

 

NOTE: Only 12-inch rear wheel is shown. All other

Permanent

Rear Wheel

Axle

wheels will install/remove in the same manner.

FIGURE 2 - INSTALLING/

4.

Repeat STEPS 2-3 for other rear wheel

REMOVING REAR WHEELS -

assembly.

PERMANENT AXLE

 

5.Adjust the wheel locks. Refer to WHEEL LOCK ADJUSTMENT in PROCEDURE 9 of this manual.

ADJUSTING THE QUICK-RELEASE AXLE (FIGURE 3)

1. Remove rear wheel and quick-release

Rear Wheel

axle from the wheelchair. Refer to

INSTALLING/REMOVING REAR

(Reference)

WHEELS in this procedure of the

Axle Mounting

manual.

Plate

 

2.Depress detent pin in the quick-release axle and slide axle through the wheel hub.

3.

Increase or decrease end play in the quick

Locking Pins

Locknut

 

 

 

release axle by adjusting the locknut on

 

Detent

 

the end of the quick-release axle.

 

 

 

Pin

4.

Reinstall rear wheel onto the wheelchair.

 

 

 

 

Refer to INSTALLING/REMOVING REAR

Wheel Hub

Quick-

 

WHEELS in this procedure of the manual.

5.

Release detent pin ensuring that the

(Reference)

Release

 

Axle

 

locking pins are fully released.

 

 

 

 

6.

Repeat STEPS 3-5 until the quick-release

FIGURE 3 - ADJUSTING THE

 

axle locks properly.

QUICK-RELEASE AXLE

7. Repeat STEPS 1-6 for opposite side, if necessary.

Solara™

50

Part No. 1080556 Rev. I

Page 49 Page 51
Image 50
Page 49 Page 51
Contents Solara SolaraLimited Solara Table of Contents Procedure 7 TILT-IN-SPACE Special Notes Special NotesHeavy Duty Package only Label LocationsLabel Locations Transport Ready Option only Specifications SpecificationsAnterior Forward Tilt Information for Healthcare PROFESSIONALS/ AssistantsGeneral Guidelines General GuidelinesStability ALL Models Except Recliners Procedure General GuidelinesStability ALL Models Stability WarningGeneral Warnings Stability Recliner Models onlyOperating Information Weight Training Weight LimitationCoping with Everyday Obstacles SAFETY/HANDLING of WheelchairsStability and Balance Unoccupied Occupied Percentage of Weight DistributionCenter Gravity General Guidelines Method 1 Wheelchair with Step Tubes Procedure General Guidelines TippingTipping Curbs Method 1 Wheelchair with Step Tubes Tipping Curbs Method 2 Wheelchair Without Step TubeStairways Method 2 WheelchairWithout Step Tube ESCALATORS? Sorry Transferring to and from Other SeatsSafety Inspection Safety Inspection ChecklistSafety Inspection Procedure 2SAFETY Inspection TroubleshootingMaintenance Maintenance Safety PrecautionsTransporting Transporting the Invacare SolaraTransporting Installing INSTALLING/REMOVING Swingaway Footrest FigureProcedure Front Riggings Front RiggingsMFX and 90 Footrests Figure Adjusting Swingaway Footrest HeightHeight Adjustment Ranges Installing Adjustable Angle FLIP-UP Footplate Hinge Figure Installing Adjustable Angle FLIP-UP Footplate HingeReplacement Figure COMPOSITE/ARTICULATING Footplate Heel LoopAdjusting the Calfpad Adjusting the Elevating LEGREST/CALFPAD Assembly FigureAdjusting the Legrest Removing Armrest Arms ProcedureInstalling Armrest ArmsProcedure Arms Adjusting Armrest INSTALLING/REMOVING/ADJUSTING Dual Point ArmrestAdjusting Locking Cantilever ARM Height Figure USING/INSTALLING/ADJUSTING Locking Cantilever ArmsUsing Locking Cantilever Arms Figure RearAdjusting Locking Cantilever ARM Angle Figure Procedure Arms110 120 Adjusting NON-LOCKING Cantilever ARM Height Figure USING/INSTALLING/ADJUSTING NON-LOCKING Cantilever ArmsUsing NON-LOCKING Cantilever Arms Figure Detail a Side View of CAM ARM AngleInstalling T-ARMS ARM PAD Replacement for Cantilever Arms FigureINSTALLING/REMOVING T-ARMS Figure Removing T-ARMSAdjusting the T-ARMS Adjusting T-ARM Height FigureProcedure Arms Adjusting T-ARM Depth Figure Adjusting T-ARM Sockets FigureAdjusting T-ARM Transfer Assists AND/OR Side Guards Figure Adjusting T-ARM Transfer Assists AND/OR Side GuardsBACK/SEAT FOLDING/UNFOLDING Back Assembly FigureProcedure BACK/SEAT Removing INSTALLING/REMOVING the Stroller Handles FigureInstalling Removing Figure Installing FigureDetail a QUICK-RELEASE PIN Installed Adjusting Figure Locked PositionINSTALLING/REPLACING Seat Positioning Straps Figure ReplacingINSTALLING/REPLACING the Back Upholstery Figure BACK/SEATPROCEDUREWheelchair Front Installing the Seat Cushion FigureRear TILT-IN-SPACE Engaging TILT-IN-SPACE FigureTILT-IN-SPACE Adjusting Trigger Release Cables Figure Procedure TILT-IN-SPACETilt Locking Collar Adjusting Upper Tilt Locking Collar FigurePositioning Tilt Locking Collars Adjusting Lower Tilt Locking Collar QUICK-RELEASE Figure INSTALLING/REMOVING Rear WheelsWHEELS/FORKS WHEELS/FORKSPermanent Axle Adjusting the QUICK-RELEASE Axle FigureProcedure WHEELS/FORKS Permanent Axle Figure QUICK-RELEASE AxleSEAT-TO-FLOOR Height Adjustment Adjusting Forks FigureWheel LOCKS/ ANTI-TIPPERS Wheel Lock Adjustment FigureProcedure Wheel LOCKS/ANTI-TIPPERS Foot Activated Wheel Lock Inch Wheels onlyFoot Activated Wheel Locks 12-INCH Wheels only Figure Using the Wheel LocksINSTALLING/ADJUSTING ANTI-TIPPERS Figure LOCKS/ -TIPPERSINSTALLING/ADJUSTING ANTI-TIPPERS ANTI-TIPPER Facing DownRecliner Back Option Recliner Operation FigureRecliner Back Option Procedure Recliner Back Option Recliner OperationBack Upholstery Adjusting the Recliner CablesReplacing BACK/HEADREST Upholstery Figure Headrest UpholsteryRemoving Existing Recliner Cables Installing NEW Recliner CablesReplacing the Recliner Cables Figure Option Detail aDetail B Replacing the GAS Cylinders Figure Actuator Centered TOO LOW TOO HighReplacing the GAS Cylinders Performing Adjustments Adjusting the GAS Cylinders FigureDetermining Necessary Adjustments Detail B Must TOO TOO Look LOW High Like this Installing the Crossmember Assembly Figure Installing the Contracture Footplate AssemblyProcedure Contracture Footplate Option Contracture Footplate OptionDetail B Lock Contracture Assembly Angle Adjustment Figure Using the Optional QUICK-RELEASE PIN FigureAngle Adjustment of the Contracture Contracture Footplate Height Adjustment Figure Bilateral ContractureReplacing the Contracture Footplate Heel Loop Figure Replacing the Contracture Footplate Heel LoopTransport Ready Option Transport Ready OptionCompliance Information Securing the Wheelchair to the VehicleWHEELCHAIR-ANCHORED Belts Figure Securing the OccupantSecurement Points Figure Front Rear Procedure Transport Ready Option Detail a Pelvic Belt WHEELCHAIR-ANCHORED BeltsTransport Ready Positioning Belts FigurePositioning Belts Part No Rev Solara Warranty WarrantyOne Invacare Way
Top Page Image Contents