Invacare 1080556 manual USING/INSTALLING/ADJUSTING NON-LOCKING Cantilever Arms

ARMS

PROCEDURE 5 ARMS

USING/INSTALLING/ADJUSTING NON-LOCKING CANTILEVER ARMS

WARNING

DO NOT use lap trays with non-locking cantilever arms.

USING NON-LOCKING CANTILEVER ARMS (FIGURE 5)

1. Pull the end of the cantilever arm down	Back Cane
to lower the cantilever arm.

ARMS

2. Pull the end of the cantilever arm up to move it out of the way.

REAR

Cantilever Arm

FIGURE 5 - USING NON-LOCKING

CANTILEVER ARMS

INSTALLING NON-LOCKING CANTILEVER ARMS (FIGURE 6)

1.Remove the locknut and washer from the lower hex bolt installed on the non-locking cantilever arm.

2.Slide the hex bolt of the cantilever arm assembly into the desired mounting hole on the back cane.

3.Secure the cantilever arm to the wheelchair with a washer and locknut as shown in FIGURE 6.

4.Adjust the angle of the cantilever arm, if necessary. Refer to ADJUSTING NON-LOCK- ING CANTILEVER ARM ANGLE in this section of the manual.

ADJUSTING NON-LOCKING CANTILEVER ARM HEIGHT (FIGURE 6)

1.	Remove the locknut and washer from
	the lower hex bolt securing the cantile-
	ver arm to the back cane.
2.	Slide the cantilever arm assembly out of
	the back cane.
3.	Reposition the cantilever arm assembly
	to the desired mounting hole.

Coved Washers

and Spacer

Lower Hex Bolt

Back Cane

Locknut

Washer

Cantilever Arm

4. Secure the cantilever arm to the wheel-

chair with a washer and locknut as

shown in FIGURE 6.

FIGURE 6 - INSTALLING NON- LOCKING CANTILEVER ARMS/ ADJUSTING NON-LOCKING CANTILEVER ARM HEIGHT

Solara™ 32 Part No. 1080556 Rev. I