Invacare 1080556 manual Adjusting Swingaway Footrest Height, Height Adjustment Ranges

Footrest

FIGURE 2 - ADJUSTING

SWINGAWAY FOOTREST

HEIGHT - 60°, 70° AND 70° TAPER

FRONT RIGGINGS PROCEDURE 4

ADJUSTING SWINGAWAY FOOTREST HEIGHT

HEIGHT ADJUSTMENT RANGES:

60°	13-17-inches
70°	13-17-inches
90°	5-8-inches
90°	5-11-inches (with 3-inch extension)

NOTE: If using ANY type of extension with the ADJUSTABLE FLIP-UP FOOTPLATE, refer to

ADJUSTABLE ANGLE FLIP-UP FOOTPLATE PER- PENDICULAR AND/OR INVERSION/EVERSION ADJUSTMENT in this procedure of the manual.

Hex Screw

Coved

Spacer

Footrest Upper

Support

Mounting

Tube

FRONT RIGGINGS

60°, 70° and 70° Taper (FIGURE 2)

1. Remove the footrest from the wheelchair. Refer to INSTALLING/REMOVING

SWINGAWAY FOOTREST in this procedure of the manual.

2. Remove the hex screw and coved spacer and slide the footrest up or down on its mounting tube until the desired footrest height is achieved.

3. Reassemble the hex screw and coved spacer through the footrest upper support and mounting tube as shown in FIGURE 2.

4. Securely tighten the hex screw and coved spacer.

5. Install the footrest assembly onto the wheelchair. Refer to INSTALLING/REMOVING SWINGAWAY FOOTREST in this procedure of the manual.

6. Repeat STEPS 1-5 for the opposite side of the wheelchair, if necessary.

70° MFX AND 90° FOOTRESTS (FIGURE 3)

1.Remove any accessories that are attached to the footrests.

2.Remove the socket bolt, coved washer and locknut that secure the footplate to the footrest support.

3.Reposition the footplate to the desired height.

4.Reinstall the socket bolt through the mounting holes of the footplate and footrest support.

WARNING

DO NOT overtighten socket bolt and locknut. Footrest MUST be able to rotate upward from the horizon- tal to the vertical position.

Footrest Support

Height

Adjustment

Holes

Locknut Socket Bolt

Footplate

FIGURE 3 - INSTALLING/REMOVING/

ADJUSTING THE FOOTREST(S) - 70° MFX AND 90° FOOTRESTS

5.Secure the footplate to the footrest support with the coved washer and locknut.

Part No. 1080556 Rev. I 23 Solara™