Toshiba DKA-AG-SYSTEMVD manual Direct Inward System Access Disa Security Code

Setting System Parameters

Direct Inward System Access (DISA) Security Code

Direct Inward System Access (DISA) Security Code

The Direct Inward System Access feature is used when calling into your system from the outside. This feature is available on certain CO lines and from the built-in Auto Attendant. Assignments are made by the system programmer. CO lines can be DISA lines in the Day, Day 2, or Night mode, or any combination of these modes.

If a caller enters the system via a DISA line or built-in Auto Attendant, the caller can then access another line to place an outgoing call through the system, in which case the outgoing line call is charged as a call made from the DK system. To prevent unauthorized outgoing calls through the system using the DISA feature, enter a DISA security code as shown in the following steps.

CAUTION! Whenever the built-in Auto Attendant is installed, the DISA security code should be used (and changed periodically) to prevent unauthorized access of outgoing CO lines via the Auto Attendant DISA access feature.

➤To enter or change the DISA security code

1.	Press [DN] + ￿￿￿￿.
2.	Dial the new DISA
	security code (1~15
	digits).
3.	Press 5HGLDO.

You hear a confirmation tone.

The DISA security code digit length is a system program option. The code appears on the LCD as you enter it.

You hear a confirmation tone.

NO. NNN

____ ID CODE SET

NO. NNN DATA PROGRAMMED

4. Press 6SNU.

The telephone returns to the idle mode.

Strata DK System Administrator Guide 5/00 5