VTech DS6121-4 user manual To one minute for this to take place

Troubleshooting

Problem	Suggestion
The answering system	• Make sure your remote access code is correct (page 39).
does not respond to	• Make sure you are calling from a touch-tone telephone. When dialing a number, there should
remote commands.	be tones. If there are clicks, then it is not a touch-tone telephone and cannot activate the
	answering system.
	• The answering system may not detect the remote access code when your announcement is
	playing. Wait until the announcement is over before entering the code.
	• There may be interference on the telephone line you are using. Press the dial pad keys firmly
	when dialing.
Common cure for	• If the telephone is not responding normally, try putting the cordless handset in the telephone
electronic equipment.	base or the charger. If it does not respond, try the following (in the order listed):
	• Disconnect the power to the telephone base.
	• Disconnect the battery on the cordless handset.
	• Wait a few minutes before connecting power to the telephone base.
	• Re-install the battery and place the cordless handset in the telephone base or charger.
	• Wait for the cordless handset to synchronize its connection with the telephone base. Allow up
	to one minute for this to take place.

www.vtechphones.com

61

Appendix