VTech DS6121-4 user manual Battery installation and charging

Page 7

Charge light

Getting started

Battery installation and charging

Install the battery as shown below. After installing the battery, you might be able to make and receive short calls. For best performance, charge the handset for at least 16 hours before use. When the battery power is low, the handset will beep, display LOW BATTERY and will flash on the handset screen. Place the handset in the telephone base or charger to charge the battery when not in use. See the table on page 51 for battery operating times.

1. Insert the plug of the battery as indicated. Make sure it is plugged securely and matches the color-coded label inside the battery compartment.

2. Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.

3. Align the cover flat against the battery compartment, then slide it upwards until it clicks into place.

4. Charge the handset by placing it in the telephone base or charger. The handset charge light will be on when charging.

1

2

3

4

•If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage.

•To purchase replacement batteries, visit our website at www. vtechphones. com or call

1 (800) 595-9511. In Canada, go to www.vtechcanada. com or call 1 (800) 267-7377.

Getting started Basic operation

www.vtechphones.com

Image 7

Contents User’s manual Congratulations Table of contents Answering system Getting started Parts checklistTelephone base and charger installation Battery installation and charging Wall mounting bracket installation Mounting bracket installationDesktop/tabletop bracket installation MUTE/REMOVE Handset layoutDelete Telephone base layoutRinger volume handset Telephone settingsRinger tone Language Key toneClear voice mail Telephone BasicsettingsoperationEnd a call VolumeMake a call Answer a callRinger mute MuteCall waiting Find handset Chain dialingModel DS6121-2 IntercomConference call Flash OFF/CLEAR or INT Transfer an external callTransfer to Calling Handset Handset X is Calling Intercom Switch between external and intercom call Answer an incoming call during an intercom call Directory Store a directory entry Character chart Dial a directory entry Search the directoryEdit a directory entry Delete from the directory About caller ID Call log Review the call log Missed calls indicatorDial a call log entry Make a call log entry ready to dialUnable to Save Save a call log entry to the directoryCALLS? Delete from the call logDisplays When Call log display screen messagesDial a redial entry Redial listDelete from redial Message capacity Answering system and voicemailSet the clock Activate the answering systemSet number of rings Answering system setupSet telephone base ringer volume Set message alert tone Set remote access codePlay your announcement Outgoing announcementDelete your announcement Record your own announcementMessage playback New message indicationOptions during playback Memo playback Delete all messagesRecord and play memos Record a memoCall intercept Call screeningWindow displays Descriptions Message window displaysCommand Function Remote accessHandset display screen messages You Handset and telephone base indicators Handset lights NEW Handset and telephone base indicators Handset iconsBattery Important safety instructions Problem Suggestion TroubleshootingLight on the handset should be on Apply Base to synchronize Handset System does CONNECTING... is Answering system To one minute for this to take place Operating range MaintenanceRbrc seal About cordless telephonesWhat does this limited warranty cover? WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsFCC, Acta and IC regulations Technical specifications Index Index 91-001513-060-100