Avaya 700217243 manual Initializing the System

2 Installing Your System Quick Reference Guide

Initializing the System

To initialize the system, you must insert any PC Card before powering up the system.

You must power down the system before you insert or remove a PC Card.

Follow these steps to initialize a system:

1If your PC Card comes with a write-protect tab, verify that the write-protect tab on the PC Card is not in the write-protected position. If it is, use a paperclip or another pointed object to push the write-protect tab on the end of the PC Card upward to the nonprotected position.

2To insert the PC Card, hold it with the label facing to the right, and slide it gently into one of the PC Card slots on the processor module. When inserted properly, the PC Card projects about 1-5/8” (4 cm) from the module.

3If you have a 5-slot carrier, make sure the carrier’s On/Off switch is at the Off (“O”) position.

4Press the power cord firmly into the power jack on the carrier or the stand-alone processor module until the cord locks into place.

5Plug the other end of the power cord into a properly grounded three-prong wall outlet that is not controlled by a switch.

6If you have a 5-slot carrier, move the On/Off switch to the On (“–”) position.

CAUTION:

The power cord should hang straight down from the connector for the entire length of the module or carrier. Do not install the power cord at an angle to the case or with a loop in it.

14 Installing the Control Unit