Avaya 700217243 manual Maintaining Your System

6 Maintaining Your System Quick Reference Guide

4For a 2-slot carrier configuration, do the following:

aRemove the long screw at the bottom of the modules.

bRemove the screws that attach the carrier to the modules.

cPull the carrier to the right to remove it.

dSlide the top module to the left to disengage its interlocking mounting tracks from the processor module.

If you are replacing the processor module, go to Step e. If you are replacing the top module, continue with Step g.

eRemove the screw at the top of the processor module, and remove the module from the wall.

fMount the new PARTNER ACS processor module by following the instructions in “Wall-Mounting a Stand-Alone Processor Module and a 2-Slot Carrier” on page 8 and “Inserting Batteries in the Processor Module” on page 12.

gMount or remount the top module by following the steps in “Wall-Mounting a Stand-Alone Processor Module and a 2-Slot Carrier” on page 8.

5Connect the line and extension cords one at a time, making sure to place the correct cords into their corresponding jacks on the new module. (See “Connecting Lines and Extensions” on page 16.)

6Reconnect the power cord.

CAUTION:

The power cord should hang straight down from the connector, flush against the plastic case. Do not install the power cord at an angle to the case or with a loop in it.

66 Replacing Modules