Xantrex Technology XC2524, XC5012 Configuring the XC Series, To configure the battery bank type

Configuring the XC Series

Configuring the XC Series

Once the charger is connected to a battery on bank 1 or to AC, it is live and it may be configured. There will be a short delay of about 15 seconds before the remote display begins reporting. The remote display will use this time to query the charger for the current operating conditions.

If AC was already applied, ensure that the charger is in on by pressing ON/STANDBY if necessary.

To configure the battery bank type:

1.	Press and hold MODE until		(setup) is displayed.
2.	Press TYPE to select the battery type configuration programming mode.
	The XC Series will default to Bank 1 and will show the present battery type
	setting.
3.	Press BANK repeatedly to select which bank you are setting up. The bank
	indicator light will illuminate to show which bank has been selected.
4.	Press TYPE repeatedly to select the battery type for each bank. When you have
	selected a battery type that is different from the present configuration, the bank
	indicator light flashes.
	Set the TYPE according to the table below:
	If your battery is				then select
	Flooded Lead Acid (has removable caps intended for refilling)
	GEL (any sealed type except AGM)				FLa
	Absorbed Glass Mat (AGM)				GEL
	Lead Calcium
	set				AGM
	Custom (if pre-configured at factory)
5.	Press and hold ON/STANDBY until			is displayed to store the selected battery
	type. If	is displayed, verify that you are setting the correctLdCbattery type and
	try again.
6.	Repeat steps 1 through 4 for all banks attached to the XC Series. Each time
	is displayed for a newly programmed battery type, the charger exits the
	programming mode.
7.	At any time during setup, you can press ON/STANDBY once to c ncel the current
	change and return to charging or battery monitoring.				CUS
975-0187-01-01		no	yes			2–15yes