Hitachi C 10FS instruction manual Groove cutting procedures, Cutting depth adjustment procedure

English

Head		Head
r	Bevel Angle Scale
			Bevel Angle Scale
	q	e	w
	Fence	Fence
	Base		Base
Miter Angle
	Turntable	Turntable	Miter Angle
Scale			Scale
	Fig. 34		Fig. 36
Fence		Fence
B	A	A	B
	Table on Base		Table on Base
	Fig. 35		Fig. 37

11. Groove cutting procedures

Cut grooves with saw blade

	8mm Depth Adjustment Bolt
a	8mm
	Wing Nut
	b
b
	Bottom Line of
	the Groove	Turntable
Fig. 38		Fig. 39

Grooves in the workpiece can be cut as indicated in Fig. 38 by adjusting the 8mm depth adjustment bolt.

Cutting depth adjustment procedure:

(1)Loosen the 8mm wing nut and turn the 8mm depth adjustment bolt by hand.

(2)Adjust to the desired cutting depth by setting the distance between the saw blade and the surface of the base (see b in Fig. 38).

(3)The 8mm wing nut must be properly tightened after the adjustment has been completed.

NOTE: When cutting a single groove at either end of the workpiece, remove the unneeded portion with a chisel.

22