Hitachi EC119 OM instruction manual Service and Repairs, Draining tank, Oil change-oil topping off

Page 13

English

2. Draining tank

Drain tank daily or after 4 hours of use. Open drain fitting and tilt compressor to empty accumulated water (Refer to Fig. 7).

3. Oil change-oil topping off

CAUTION : Overfilling with oil will cause premature compressor failure. Do not overfill.

(1)Within the first 50 hours of operation, completely replace the oil of the pumping element. Unfasten the oil drain cap on the casing cover, drain all the oil, and screw the cap back on (Refer to Fig. 1 and Fig. 10).

Drain cap

Fig. 10

Pour oil into the hole of the dipstick.

To the level indicated on the dipstick (Refer to Fig. 4).

For oil replacement, follow the table below.

OIL TYPE

SAE 5W50 SYNTHETIC OIL (–20°+120°F)

For both summer and winter use

SAE 10W40 MULTI-GRADED OIL (+50°+120°F)

For warm weather use only

(2)Check the oil level of the pumping element every 50 hours or once a week.

(3)Change the oil every 300 working hours or every 6 months.

SERVICE AND REPAIRS

All quality compressors will eventually require servicing or replacement of parts because of wear from normal use. To assure that only authorized replacement parts will be used, all service and repairs must be performed by a

HITACHI AUTHORIZED SERVICE CENTER, ONLY.

NOTE:Specifications are subject to change without any obligation on the part of the HITACHI.

— 13 —

Image 13
Contents Avertissement Safety Operation and MaintenanceSécurité Utilisation ET EntretienImportant Information Meanings of Signal WordsSafety Keep ALL SCREWS, Bolts and Covers Tightly in Place Keep Motor AIR Vent CleanOperate Compressor AT the Rated Voltage Do not Modify the CompressorSafety Valve Must Work Properly Replacement PartsExtension Cord Grounding InstructionsMake Them Available to Other Users of this Tool Name of Parts Operation and MaintenanceAccessory SpecificationsStandard Accessory Prior to OperationOperation TransportCleaning the intake filter MaintenanceShutdown About the thermal protectorDraining tank Service and RepairsOil change-oil topping off Informations Importantes Signification DU Vocabulaire DE SignalisationBien Lire Toutes LES Instructions SécuritéRester SUR SES Gardes Cordons DE Rallonge Pour Utilisation À L’EXTÉRIEURContrôler LES Piéces Endommagées ET LES Fuites D’AIR Maintenir L’ÉVENT D’AÉRATION DU Moteur PropreVidanger LE Réservoir Pièces DE RechangeNE PAS Arrêter LE Compresseur EN Tirant SUR LA Fiche LA Valve DE Sécurité Doit Fonctionner CorrectementCordon DE Rallonge Instructions DE Mise À LA TerreFrançais NOM DES Pièces Utilisation ET EntretienRemarque Accessoire Standards Accessoire AvertissementAvant L’UTILISATION Utilisation Entretien PrecautionArrêt Propos du protecteur thermiqueVidange du réservoir Service APRÈS-VENTE ET RéparationsChangement d’huile/Débordement d’huile Significado DE LAS Palabras DE Señalización Información ImportanteLEA Todas LAS Instrucciones SeguridadCompruebe SI HAY Piezas Dañadas O Fugas DE Aire Mantenga AlertaUtilice Correctamente EL Compresor Operar EL Compresor AL Voltaje EspecificadoLA Válvula DE Seguridad Debe Funcionar Correctamente Piezas DE ReemplazoCable Prolongador Instrucciones Para LA Puesta a TierraEspañol Nomenclatura Operación Y MantenimientoNota Accesorio EspecificacionesAccesorio Estándar AplicacionesOperación TransporteAcerca del protector térmico Ajuste la presión de trabajoCierre Servicio Y Reparaciones MantenimientoLimpieza del filtro de entrada Drenaje del depósitoPage Code No Part Name ’ty Page Page Hitachi Koki Canada Co