
Attaching or Removing Bat- tery Pack
1.To connect the battery pack:
Line up the alignment marks and
Slide the battery pack until it locks into position.
Alignment marks
2.To remove the battery pack:
Push on the button from the front to re- lease the battery pack.
2.A feedback electronic controller is used to give a strong torque even in low speed.
3.The brake operates when the trig- ger is released and the motor stops immediately.
NOTE:
When the brake operates, a brak- ing sound may be heard. This is normal.
Switch and Forward/Reverse Lever Operation
Button
Support handle
Place the support handle at your favorite position and tighten the handle securely.
Tighten
Loosen
Remove the handle when placing the tool in the storage case.
VI. OPERATION
[Main Body]
Switch Operation
1.The speed increases with the amount of depression of the trigger. When beginning work, depress the trigger slightly to start the rotation slowly.
ForwardReverse
Switch lock
CAUTION:
To prevent damage, do not operate Forward/Reverse lever until the bit comes to a complete stop.
Forward Rotation Switch Operation
1.Push the lever for forward rotation.
2.Depress the trigger switch slightly to start the tool slowly.
3.The speed increases with the amount of depression of the trigger for efficient tightening of screws and drilling. The brake operates and the chuck stops immediately when the trigger is released.
4.After use, set the lever to its center position (switch lock).
Reverse Rotation Switch Operation
1.Push the lever for reverse rotation. Check the direction of rotation before use.
2.Depress the trigger switch slightly to start the tool slowly.
- 8 -