Panasonic EYFLA1A IV. Assembly, Attaching Socket, Attaching or Removing Bit, Removing Socket

Symbol			Meaning
		V	Volts
			Direct current
		n0	No load speed
… min-1			Revolutions or reciprocations
			per minutes
	Ah		Electrical capacity of battery
			pack
			Read the operating
			instructions before use.
			For indoor use only.

Attaching Socket

•Remove the socket’s rubber ring and pin.

rubber ring groove

pin

1 Attach the socket to the tool.

2 Insert the pin. (Taking care to align the pin holes on the socket and tool.)

3 Attach the rubber ring by sliding it into place over the groove.

IV. ASSEMBLY

Attaching or Removing Bit

NOTE:

•When attaching or removing a bit, discon- nect battery pack from tool or place the switch in the center position (switch lock).

1.Hold the collar of quick connect chuck and pull it out from the tool.

2.Insert the bit into the chuck. Release the collar.

3.The collar will return to its original position when it is released.

4.Pull the bit to make sure it does not come out.

5.To remove the bit, pull out the collar in the same way.

CAUTION:

•If the collar does not return to its origi- nal position or the bit comes out when pulled on, the bit has not been properly attached. Make sure the bit is properly attached before use.

EYFLA1A/EYFLA2A

12 mm	9 mm – 9.5 mm	6.35 mm
(15/32")	(23/64" – 3/8")	(1/4")

NOTE:

Be sure to attach the rubber ring to prevent the pin from falling out.

Removing Socket

1 Remove the rubber ring.

2 Remove the pin.

3Remove the socket from the tool.

NOTE:

Keep the temperature of the tool above the freezing point (0°C/32°F) when attach­ ing sockets to or detaching them from the square drive on the tool. Do not use excessive force when attaching or detach­ ing sockets.

Attaching or Removing Bat­ tery Pack

1.To connect the battery pack:

Line up the alignment marks and attach the battery pack.

•Slide the battery pack until it locks into position.

- -