Porter-Cable N003568 Check Valve, Motor Overload Protector not shown, How to Stop

Page 11

Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.

Drain Valve: The drain valve is located at the base of the

 

 

 

 

 

 

air tank and is used to drain condensation at the end of

 

 

 

each use.

 

 

 

 

 

 

 

 

Drain

 

Check Valve:

When the air compressor is operating, the

 

 

 

Valve

 

check valve is "open", allowing compressed air to enter

 

 

 

 

 

 

the air tank. When the air compressor reaches "cut-out"

 

 

 

pressure, the check valve "closes", allowing air

 

 

 

 

 

 

 

 

pressure to remain inside the air tank.

 

 

 

 

Motor Overload Protector (not shown): The

 

 

 

 

motor has an automatic reset thermal overload

Check Valve

protector. If the motor overheats for any reason,

 

 

 

 

the overload

protector will shut off the motor.

 

 

 

 

The motor must be allowed to cool down before restarting. The compressor will automatically restart after the motor cools.

How to Use Your Unit

How to Stop

1.Set the On/Off switch to "Off".

Before Starting

Do not operate this unit until you read and understand this instruction manual for safety, operation and maintenance

instructions.

Break-in Procedure

Risk of Unsafe Operation. Serious damage may result if the following break-in instructions are not closely followed.

This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.

1.Make sure the On/Off switch is in the "Off" position.

2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)

3.Open the drain valve (counter-clockwise) fully to permit air to escape and pre- vent air pressure build up in the air tank during the break-in period.

4.Move the On/Off switch to "On" position. The compressor will start.

5.Run the compressor for 15 minutes. Make sure the drain valve is open and there is minimal air pressure build-up in tank.

6.After 15 minutes, close the drain valve by turning clockwise. The air receiver will fill to "cut-out" pressure and the motor will stop.

The compressor is now ready for use.

Before Each Start-Up

1.Set the On/Off switch to "Off".

2.Turn the regulator knob counter-clockwise to set the outlet pressure to zero.

3.Attach hose and accessories.

Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip.

Risk of unsafe operation. Do not use damaged or worn accessories.

11 - ENG

N003568

Image 11
Contents C2002 Hazard Safety Guidelines DefinitionsImportant Safety Instructions Risk to Breathing Asphyxiation What can happen How to prevent itResult in serious injury Attachments & accessoriesRisk of Bursting Tires Over inflation of tires couldRisk from Flying Objects Risk of Electrical ShockElectrical Grounding Failure Grounding Instructions paraRisk of Unsafe Operation Risk of Hot surfaces What can happen How to prevent itRisk from Moving Parts Model No C2002 Risk of FallingRisk from noise Glossary AccessoriesAssembly InstallationVoltage and Circuit Protection Extension CordsDescription of Operation OperationKnow Your Air Compressor Motor Overload Protector not shown How to StopBefore Starting Instructions Break-in Procedure Check ValveCustomer Responsibilities MaintenanceTo Check Safety Valve How to StartTo Drain Tank Service and AdjustmentsTo Replace or Clean Check Valve Pump shown moved out of the way Regulator Manifold To Replace RegulatorStorage ServiceTroubleshooting Description Overload Protection Full One Year Warranty Blessures ou la mort Des blessures mineures ou moy Ennes Mesures DE Sécurité DéfinitionsConsignes DE Sécurité Importantes Ce qui peut se produire Comment l’Éviter Risque Repiratoire AsphyxieRisque d’Éclatement Blessures graves et des Accessoires Pneus Des pneus surgonflés Pourraient provoquer desDirectives relatives à la mise à Mise à la terre électrique leRisque associÉ À utilisation Risque associÉ auxPiÈces mobiles Modèle no C2002 SpecificationsLexique Risque associÉ au bruitAssemblage Cycle DE ServiceAccessoires Emplacement du compresseur dairProtection contre la surtension et protection du circuit RallongesDescription du fonctionnement UtilisationFamiliarisez-vous avec votre compresseur dair Arrêt de lappareil Utilisation de lappareilMise en marche Avant chaque mise en marcheVidange du réservoir EntretienResponsabilités du client Vérification de la soupape de sûretéEntretien ET Réglages Remplacement ou nettoyage de la soupape de retenuePour remplacer le régulateu Pièces DE Rechange RangementDépannage Remarque Ajustez «Description du foncMoteur » sous « Surcharge duGarantie complète d’un 1 an Remplacement Gratuit DES Étiquettes D’AVERTISSEMENT si lesLesiones serias Puede causar lesiones menores o Moderadas Definiciones DE Normas DE SeguridadInstrucciones Importantes DE Seguridad Peligro¿Qué puede suceder? Cómo evitarlo Riesgo Respiratorio asfixiaRiesgo de explosión Lesiones graves y daño a la Elementos y accesoriosNeumáticos El inflado excesivo de los Neumáticos podría causarRiesgo por piezas móviles ¿Qué puede suceder? Cómo evitarlo Riesgo DE superficies calientesRiesgo DE Caídas Modelo Nº C2002 Cuadro DE EspecificacionesGlosario Riesgo por ruidosDesempaque Ciclo DE ServicioEnsamblaje InstalaciónProtección del voltaje y del circuito Cables de extensión eléctricaDescripción de operaciones OperaciónConozca su compresor de aire Cómo detenerla Cómo utilizar su unidadProtector de sobrecalentamiento del motor Cómo poner en marcha Antes de cada puesta en marchaCómo drenar el tanque MantenimientoResponsabilidades del cliente Cómo verificar la válvula de seguridadVea Piezas de repuesto en la sección Servicio Y AjustesPara reemplazar o limpiar la válvula retención Para reemplazar el regulador Servicio AlmacenajeAccesorios Guía DE Diagnóstico DE ProblemasLas instrucciones de Sobrecalentamiento Consulte Protector dePóliza de Garantía ReparacionesManuelle CULIACAN, SIN Page Page Highway 45 North Jackson, TN 888