English
Previously pull the trigger
Trigger
4 
2 
3 
4 
Push Lever
WARNING
⬤A nail will fire each time the trigger is depressed as long as the push lever remains depressed.
(2)Continuous operation (Push lever fire) Using CONTACT ACTUATION MECHANISM
WARNING
⬤To avoid double firing or accidental firing due to
recoil.
1)Do not press the nailer against the wood with excessive force.
2)Separate the nailer from the wood as it recoils after nailing.
1Set the switching device to the rightward position (to set to CONTACT ACTUATION MECHANISM). (Set the switching device to the rightward position
completely as shown in the diagram. Otherwise, it will not operate properly.)
2Pull the trigger with the Nailer off the workpiece.
3 Depress the push lever against the workpiece to drive a nail.
4 Move the Nailer along the workpiece with a bouncing motion.
Each depression of the push lever will drive a nail. As soon as the desired number of nails have been driven, remove finger from the trigger.
1Rightward position
Switching device
WARNING
⬤Keep your finger off the trigger except during fastening operation, because serious injury could result if the push lever accidentally contacts you or others in work area.
⬤Keep hands and body away from the discharge area. This Hitachi nailer may bounce from the recoil of driving a fastener and unwanted subsequent fastener may be driven, possibly causing injury.
⬤Some types of loaded nails can spark out of the muzzle during a nail driving operation. Exercise caution!
The SINGLE SEQUENTIAL ACTUATION MECHANISM is for use where precision fastener placement is desired.
The SINGLE SEQUENTIAL ACTUATION MECHANISM may reduce the possibility of bodily injury to you or others in the work area compared to the CONTACT ACTUATION MECHANISM. This is because it is less likely to drive an unwanted nail if you keep the trigger pulled and accidentally bump the push lever against yourself or others.
The SINGLE SEQUENTIAL ACTUATION MECHANISM may also reduce the speed of operation compared to the CONTACT ACTUATION MECHANISM. The SINGLE SEQUENTIAL ACTUATION MECHANISM is recommended to inexperienced users.
NOTE:
⬤If all warnings and instructions are followed, safe operation is possible with two systems: SINGLE SEQUENTIAL ACTUATION MECHANISM and
CONTACT ACTUATION MECHANISM.
⬤Always handle nails and package carefully. If nails are dropped, collating paper may be broken.
⬤After nailing:
1)disconnect air hose from the Nailer;
2)remove all nails from the Nailer;
3)supply 5 – 10 drops of Hitachi pneumatic tool lubricant into the air plug on the Nailer; and
4)open the petcock on the air compressor tank to drain any moisture.
— 14 —